Search results
Results from the WOW.Com Content Network
Gargoyle is a free OpenWrt-based Linux distribution for a range of wireless routers based on Broadcom, Atheros, MediaTek and others chipsets, [2] [3] Asus Routers, Netgear, Linksys and TP-Link routers. Among notable features is the ability to limit and monitor bandwidth and set bandwidth caps per specific IP address. [4] [5] [6] [7]
OpenWrt (from open wireless router) is an open-source project for embedded operating systems based on Linux, primarily used on embedded devices to route network traffic. The main components are Linux, util-linux, musl, [5] and BusyBox.
Notable custom-firmware projects for wireless routers.Many of these will run on various brands such as Linksys, Asus, Netgear, etc. OpenWrt – Customizable FOSS firmware written from scratch; features a combined SquashFS/JFFS2 file system and the package manager opkg [1] with over 3000 available packages (Linux/GPL); now merged with LEDE.
ifconfig (short for interface config) is a system administration utility in Unix-like operating systems for network interface configuration. The utility is a command-line interface tool and is also used in the system startup scripts of many operating systems. It has features for configuring, controlling, and querying TCP/IP network interface ...
Then, the command ipconfig /renew is executed to request a new IP address. [ 3 ] [ 4 ] Where a computer is connected to a cable or DSL modem, it may have to be plugged directly into the modem network port to bypass the router, before using ipconfig /release and turning off the power for a period of time, to ensure that the old IP address is ...
The Internet Engineering Task Force (IETF) has reserved the IPv4 address block 169.254.0.0 / 16 (169.254.0.0 – 169.254.255.255) for link-local addressing. [1] The entire range may be used for this purpose, except for the first 256 and last 256 addresses (169.254.0.0 / 24 and 169.254.255.0 / 24), which are reserved for future use and must not be selected by a host using this dynamic ...
COMMAND: The command to run (add, delete, change, get, monitor, flush)-net: <dest> is a network address-host: <dest> is host name or address (default)-netmask: the mask of the route <dest>: IP address or host name of the destination <gateway>: IP address or host name of the next-hop router
To apply the new configuration, a SIGHUP signal must be sent to the xinetd process to make it re-read the configuration files. This can be achieved with the following command: kill -SIGHUP " PID " . PID is the actual process identifier number of the xinetd, which can be obtained with the command pgrep xinetd .