Search results
Results from the WOW.Com Content Network
Peg-Board is an expired trademark used as a brand name by the Masonite Corporation, first used in 1962, [1] which is often used as a generic term for perforated storage boards made of hardboard, wood, metal, or other material.
Keystone wall plates are made to work with many different types of cabling solutions, including coaxial, twisted pair, HDMI, optical fiber, etc. Keystone wall plates are made of plastic and have one to twelve ports. A keystone port is a hole in the wall plate which allows the insertion of a keystone module or other male or female cabling ...
Knob-and-tube wiring (sometimes abbreviated K&T) is an early standardized method of electrical wiring in buildings, in common use in North America from about 1880 to the 1930s.
7-pin ISO 1724 trailer connector type 12N (Towing vehicle side). This connector uses a mix of pin and socket terminals. Physical design according to standard ISO 1724. [4] [8] The 7-pin connector uses all 7 pins on newer trailers according to the ISO standard. [9] [10] On older trailers there's sometimes a 5-wire setup using a 7-pin connector.
As of 2009, a set of trailer skirts cost between C$1500 and C$3000 (US$1300 to $2700). [4] Standard trailer skirts have an estimated payback period of ten to eighteen months, while "advanced" skirts (those that improve fuel efficiency by over 7%) are estimated to pay for themselves in seven to fourteen months.
The peg type casement stay has one or two pins or pegs inside the rebate. The stay is a metal bar with holes that fit onto the peg, and allow the sash window to be held open in various positions. The peg nearest the hinge can then be used as a fulcrum. Disadvantages of peg type stays are that the stay handle may protrude dangerously into the room.
The Girder and Panel Building Set construction kits enabled a child to build plastic models of mid-twentieth century style buildings. Vertical plastic columns were placed in the holes of a Masonite base board and horizontal girders were then locked into the vertical columns to create the skeletal structure of a model building.
A wooden tent peg used in snow. Tent peg types and styles may typically vary in length from 150mm to 490mm, and in thickness from 1.6 mm to 3.2 mm for flat section tent pegs and from 4 mm to 11.2 mm for wire rod [2] [6] [7] tent pegs. Smaller wire tent pegs are also available, especially where weight is critical.