Search results
Results from the WOW.Com Content Network
Two different airline in-seat power supply system (ISPSS) standards for DC power have been used in the past. American Airlines in the past used an automobile auxiliary power outlet. Most other airlines that provide DC power use the smaller EmPower system, which has a 4-pin Hypertronics' D-series connector. It can supply 15 volts maximum 5 amperes.
The Certified USB Fast Charger logo indicating support for the Programmable Power Supply (PPS) protocol in USB Power Delivery (PD) chargers. On January 8, 2018, USB-IF announced the Certified USB Fast Charger logo for chargers that use the Programmable Power Supply (PPS) protocol from the USB Power Delivery 3.0 specification. [71]
A power supply is an electrical device that supplies electric power to an electrical load. The main purpose of a power supply is to convert electric current from a source to the correct voltage, current, and frequency to power the load. As a result, power supplies are sometimes referred to as electric power converters. Some power supplies are ...
In 2019 Intel released a new standard based on an all-12V design: ATX12VO. The power supply only provides 12 V voltage output; [13] 5 V, 3.3 V powers, as needed by USB, hard disk drive and other devices, are transformed on the motherboard; and the ATX motherboard connector is reduced
Common circuit diagram symbols (US ANSI symbols) An electronic symbol is a pictogram used to represent various electrical and electronic devices or functions, such as wires, batteries, resistors, and transistors, in a schematic diagram of an electrical or electronic circuit. These symbols are largely standardized internationally today, but may ...
A wiring diagram for parts of an electric guitar, showing semi-pictorial representation of devices arranged in roughly the same locations they would have in the guitar. An automotive wiring diagram, showing useful information such as crimp connection locations and wire colors. These details may not be so easily found on a more schematic drawing.
An SMPS designed for AC input can usually be run from a DC supply, because the DC would pass through the rectifier unchanged. [35] If the power supply is designed for 115 VAC and has no voltage selector switch, the required DC voltage would be 163 VDC (115 × √2). This type of use may be harmful to the rectifier stage, however, as it will ...
The power supply was required to have an output capacitive energy of less than 15.1 µJ and an inductive energy at disconnect of less than 5.3 µJ. [ 1 ] The standard defines an AC adapter to power devices requiring from 10 W to 130 W (~20 V × 6.5 A) or (extended voltage option) up to 240 W (60 V × 4 A). [ 2 ]