enow.com Web Search

Search results

1. Results from the WOW.Com Content Network

2. Slag (welding) - Wikipedia

   en.wikipedia.org/wiki/Slag_(welding)

   Removal is usually done using manual or power tools. Manual tools may include a welding or chipping hammer, which has a pointed tip on one end to break up large chunks of slag efficiently, or wire brushes. Power tools include angle grinders with grinder disks or wire brush wheels.

3. Needlegun scaler - Wikipedia

   en.wikipedia.org/wiki/Needlegun_scaler

   This can be done with solvents or with a combination of detergent and fresh water. [5] Then, the needle gun is used to remove rust, loose scale, and paint, leaving bare metal. [ 5 ] It is used most effectively by holding it at a 45° angle to the work surface. [ 5 ]

4. Grinding (abrasive cutting) - Wikipedia

   en.wikipedia.org/wiki/Grinding_(abrasive_cutting)

   A wide variety of machines are used for grinding, best classified as portable or stationary: Portable power tools such as angle grinders, die grinders and cut-off saws; Stationary power tools such as bench grinders and cut-off saws; Stationary hydro-or hand-powered sharpening stones; Milling practice is a large and diverse area of manufacturing ...

5. Combination machine - Wikipedia

   en.wikipedia.org/wiki/Combination_machine

   A combination machine takes up much less space than the equivalent separate machines. Most European machines have a sliding table that tends to make them safer than typical North American table saws. Even though top end combination machines can be quite expensive, there usually is a cost saving over separate machines of similar quality.

6. Rotary hammer - Wikipedia

   en.wikipedia.org/wiki/Rotary_hammer

   Ramset 342 Dyna Drill and Chipping Hammer, shown with chipping chisel. A rotary hammer, also called rotary hammer drill [1] is a power tool that can perform heavy-duty tasks such as drilling and chiseling hard materials. [2] It is similar to a hammer drill in that it also pounds the drill bit in and out while it is spinning. However, rotary ...

7. Welder - Wikipedia

   en.wikipedia.org/wiki/Welder

   All of these types of shocks come from the welding electrode terminal. Often these shocks are minor and are misdiagnosed as being an issue with a power tool or the power supply to the welder's area. However, the more likely cause is from stray welding current which occurs when current from the welding cables leaks into the welder's work area.