Search results
Results from the WOW.Com Content Network
The CEE 7/5 socket and CEE 7/6 plug are defined in French standard NF C 61-314 "Plugs and socket-outlets for household and similar purposes" (which also includes CEE 7/7, 7/16 and 7/17 plugs) The socket has a predominantly circular recess which is 15 mm (0.591 in) deep with two symmetrical round apertures and a round 4.8 mm (0.189 in) earth pin ...
In both the 10 A and 16 A versions, the distance between the phase conductor and the neutral conductor is 19 mm (± 0.15 mm). The protective conductor is offset by 5 mm (± 0.1 mm). In the three-phase plugs and sockets (T15 and T25), L2 and L3 are offset by 8 mm (± 0.1 mm) from the protective conductor, i.e. the distance between L1 and L2 or ...
The type 25 plug and socket has 3 rectangular pins, 4 mm x 5 mm, plus 2 flat pins (for L2 and L3). It is designed for three phase applications and is rated at 16 A, 250 V/440 V. The socket will accept types 11, 12, 21, and 23 single phase plugs, the Europlug, and types 15 and 25 three phase plugs. Swiss multi-phased sockets
Socket 7: 1994 Intel Pentium Intel Pentium MMX AMD K6: PGA: 321 ? 50–66 MHz It is possible to use Socket 7 processors in a Socket 5. An adapter is required, or if one is careful, a socket 7 can be pulled off its pins and put onto a socket 5 board, allowing the use of socket 7 processors. Socket 8: 1995 Intel Pentium Pro: PGA: 387 ? 60–66 ...
On the female socket, the major key is 4 mm deep at the 6-o'clock position. The width of the major key defines the current rating: 32 A plugs have a narrower 5 mm wide groove, while 16 A plugs have a wider 8 mm groove, and therefore 32 A plugs can be used with 16 A sockets but 16 A plugs cannot be used with 32 A sockets.
Octal bases, as defined in IEC 60067, [10] diagram IEC 67-I-5a, have a 45-degree angle between pins, which form a 17.45 mm (11 ⁄ 16 in) diameter circle around a 7.82 mm (5 ⁄ 16 in) diameter keyed post (sometimes called a spigot) in the center. Octal sockets were designed to accept octal tubes, the rib in the keyed post fitting an indexing ...
The important socket dimensions which the standard does specify are: A minimum insertion of 9.6 mm from the face of the socket-outlet to the first point of contact with a live part, [67] a minimum distance of 9.5 mm from the line and neutral apertures to the periphery of the socket face, [68] and not to exceed dimensions for the apertures of 7. ...
AS/NZS 3112 compliant plugs have two flat pins forming an inverted V-shape plus a vertical earthing pin. The flat blades measure 6.35 by 1.6 mm (1 ⁄ 4 by 1 ⁄ 16 in) with the active (line) and neutral pins 17.35 mm (11 ⁄ 16 in) long set 30° to the vertical and the vertical earth pin being 20 mm (0.787 in) in length. [15]