Search results
Results from the WOW.Com Content Network
A minimum systolic value can be roughly estimated by palpation, most often used in emergency situations, but should be used with caution. [10] It has been estimated that, using 50% percentiles, carotid, femoral and radial pulses are present in patients with a systolic blood pressure > 70 mmHg, carotid and femoral pulses alone in patients with systolic blood pressure of > 50 mmHg, and only a ...
A sphygmomanometer (/ ˌ s f ɪ ɡ m oʊ m ə ˈ n ɒ m ɪ t ə r / SFIG-moh-mə-NO-mi-tər), also known as a blood pressure monitor, or blood pressure gauge, is a device used to measure blood pressure, composed of an inflatable cuff to collapse and then release the artery under the cuff in a controlled manner, [1] and a mercury or aneroid manometer to measure the pressure.
Blood pressure (BP) is the pressure of circulating blood against the walls of blood vessels. Most of this pressure results from the heart pumping blood through the circulatory system. When used without qualification, the term "blood pressure" refers to the pressure in a brachial artery, where it is most commonly measured.
If the pressure is dropped to a level equal to that of the patient's systolic blood pressure, the first Korotkoff sound will be heard. As the pressure in the cuff is the same as the pressure produced by the heart, some blood will be able to pass through the upper arm when the pressure in the artery rises during systole.
In medicine, the mean arterial pressure (MAP) is an average calculated blood pressure in an individual during a single cardiac cycle. [1] Although methods of estimating MAP vary, a common calculation is to take one-third of the pulse pressure (the difference between the systolic and diastolic pressures), and add that amount to the diastolic pressure.
The pulse watch was first made commercially available in 1701 by Sir John Floyer, who was an English physician. Floyer wanted to develop a watch to measure the accurate pulse rates of his patients. Floyer created a watch that counted a user's heart beat for sixty seconds, it created an easier way to count and measure the heart rate of patients.
Pulse pressure is calculated as the difference between the systolic blood pressure and the diastolic blood pressure. [3] [4]The systemic pulse pressure is approximately proportional to stroke volume, or the amount of blood ejected from the left ventricle during systole (pump action) and inversely proportional to the compliance (similar to elasticity) of the aorta.
When the heart ejects stroke volume to the arteries, it takes a certain transit time until the blood pressure wave arrives in the periphery. This pulse transit time (PTT) indirectly depends on blood pressure – the higher the pressure, the faster PTT. This circumstance can be used for the noninvasive detection of blood pressure changes.