Ads
related to: fast 102mm electronic throttle body testing for saleebay.com has been visited by 1M+ users in the past month
walmart.com has been visited by 1M+ users in the past month
3579 S High St, Columbus, OH · Directions · (614) 409-0683
Search results
Results from the WOW.Com Content Network
A typical ETC system consists of three major components: (i) an accelerator pedal module (ideally with two or more independent sensors), (ii) a throttle valve that can be opened and closed by an electric motor (sometimes referred to as an electric or electronic throttle body (ETB)), and (iii) a powertrain or engine control module (PCM or ECM). [4]
A throttle position sensor (TPS) is a sensor used to monitor the throttle body valve position for the ECU of an engine. The sensor is usually located on the butterfly spindle/shaft, so that it can directly monitor the position of the throttle. More advanced forms of the sensor are also used.
In both JS-001-2012 and MIL-STD-883H the charged human body is modeled by a 100 pF capacitor and a 1500 ohm discharging resistance. During testing, the capacitor is fully charged to several kilovolts (2 kV, 4 kV, 6 kV and 8 kV are typical standard levels) and then discharged through the resistor connected in series to the device under test.
The body of DO-254/ED-80 establishes objectives and activities for the systematic design assurance of complex electronic hardware, generally presumed to be complex custom micro-coded components, as listed above. However, simple electronic hardware is within the scope of DO-254/ED-80 and applicants propose and use the guidance in this standard ...
Automatic test equipment, any apparatus that performs tests using automation; Built-in test equipment, passive fault management and diagnosis equipment built into airborne systems to support maintenance; On-board diagnostics, test equipment for automobiles; Transistor tester, used to test the electrical behavior of transistors and solid-state ...
Over time, newer techniques, such as somatosensory evoked potentials, single fiber electromyography, autonomic testing, and neuromuscular ultrasound have evolved as useful complementary techniques to nerve conduction studies and elecytromyography, which remain the core of electrodiagnostic medicine. [citation needed]
In testing electronic equipment such as circuit boards, electronic components, and chips, a test fixture is a device or setup designed to hold the device under test in place and allow it to be tested by being subjected to controlled electronic test signals. [1] Examples are a bed of nails tester or smart fixture.
Pages in category "Electronic test equipment manufacturers" The following 38 pages are in this category, out of 38 total. This list may not reflect recent changes .
Ads
related to: fast 102mm electronic throttle body testing for saleebay.com has been visited by 1M+ users in the past month
walmart.com has been visited by 1M+ users in the past month
3579 S High St, Columbus, OH · Directions · (614) 409-0683