Ad
related to: fast 102mm electronic throttle body testing for freewalmart.com has been visited by 1M+ users in the past month
Search results
Results from the WOW.Com Content Network
A typical ETC system consists of three major components: (i) an accelerator pedal module (ideally with two or more independent sensors), (ii) a throttle valve that can be opened and closed by an electric motor (sometimes referred to as an electric or electronic throttle body (ETB)), and (iii) a powertrain or engine control module (PCM or ECM). [4]
A throttle position sensor (TPS) is a sensor used to monitor the throttle body valve position for the ECU of an engine. The sensor is usually located on the butterfly spindle/shaft, so that it can directly monitor the position of the throttle. More advanced forms of the sensor are also used.
Accelerate-by-wire or throttle-by-wire, [17] more commonly known as electronic throttle control, is a system that actuates vehicle propulsion without any mechanical connections, such as cables, from the accelerator pedal to the throttle valve of the engine or other propulsion systems. In electric vehicles, this system controls the electric ...
There is essentially no difference in efficiency between the technique of bypassing the throttle butterfly and operating the butterfly itself. The IAC allows the ECU to maintain minimum RPM irrespective of changes in engine load, sometimes referred to as anti-stall feature. Thus the driver can more easily move the car from stand-still by merely ...
The Ford EEC or Electronic Engine Control is a series of ECU (or Engine Control Unit) that was designed and built by Ford Motor Company. The first system, EEC I, used processors and components developed by Toshiba in 1973. It began production in 1974, and went into mass production in 1975. It subsequently went through several model iterations.
List of free analog and digital electronic circuit simulators, available for Windows, macOS, Linux, and comparing against UC Berkeley SPICE.The following table is split into two groups based on whether it has a graphical visual interface or not.
The advent of concern about fuel economy and emissions had major impacts on engine design. Some of the trade-offs reduced throttle response. Most new cars employ a drive-by-wire system, which includes electronic throttle control and can itself either reduce or increase throttle response (Depending on whether or not it's being employed on a performance car).
At take-off, the flight crew advances the power lever to a predetermined setting, or opts for an auto-throttle take-off if available. The FADECs now apply the calculated take-off thrust setting by sending an electronic signal to the engines; there is no direct linkage to open fuel flow. This procedure can be repeated for any other phase of flight.
Ad
related to: fast 102mm electronic throttle body testing for freewalmart.com has been visited by 1M+ users in the past month