Search results
Results from the WOW.Com Content Network
hazard lights switch 85c hazard sound on Switches 81 opener 81a 1 out 81b 2 out 82 lock in 82a 1st out 82b 2nd out 82z 1st in 82y 2nd in 83 multi position switch, in 83a out position 1 83b out position 2 Relay; 85 relay coil - Important if relay coil has flyback diode in parallel 86 relay coil + Important if relay coil has diode in parallel
The mini-DIN connectors are a family of multi-pin electrical connectors used in a variety of applications. Mini-DIN 9.5 millimetres ( 3 ⁄ 8 in) is similar to the larger, older 13.2 mm diameter DIN connector .
Original file (SVG file, nominally 455 × 455 pixels, file size: 6 KB) This is a file from the Wikimedia Commons . Information from its description page there is shown below.
Knob-and-tube wiring (sometimes abbreviated K&T) is an early standardized method of electrical wiring in buildings, in common use in North America from about 1880 to the 1930s.
A light switch may cause a small, harmless spark when switched on or off. In an ordinary household this is of no concern, but if a flammable atmosphere is present, the arc might start an explosion. In many industrial, commercial, and scientific settings, the presence of such an atmosphere is a common, or at least commonly possible, occurrence.
NEMA 1-15P (two-pole, no ground) and NEMA 5-15P (two-pole with ground pin) plugs are used on common domestic electrical equipment, and NEMA 5-15R is the standard 15-ampere electric receptacle (outlet) found in the United States, and under relevant national standards, in Canada (CSA C22.2 No. 42 [1]), Mexico (NMX-J-163-ANCE) and Japan (JIS C 8303).
A safety wire is used to ensure proper security for a fastener. The wire needed is long enough to reach from a fixed location to a hole in the removable fastener, such as a pin — a clevis fastener, sometimes a linchpin or hitch-pin through a clevis yoke for instance — and the wire pulled back upon itself, parallel to its other end, then twisted, a single end inserted through a fastener ...
In 1937 W.B. Schulte, [2] McGall's employer, started the company MICRO SWITCH. The company and the Micro Switch trademark have been owned by Honeywell Sensing and Control since 1950. [3] The name has become a generic trademark for any snap-action switch. Companies other than Honeywell now manufacture miniature snap-action switches.