Search results
Results from the WOW.Com Content Network
Two king post trusses linked to support a roof. Key:1: ridge beam, 2: purlins, 3: common rafters. This is an example of a "double roof" with principal rafters and common rafters. A timber roof truss is a structural framework of timbers designed to bridge the space above a room and to provide support for a roof.
The Braga Bridge is a continuous truss bridge. It was the fourth longest span of this type when it was completed in 1966. This list of continuous bridge spans ranks the world's continuous truss bridges in two listings: The first is ranked by the length of main span (the longest length of unsupported roadway) and the second by the total length of continuous truss spans.
The first Howe truss ever built was a single-lane, 75-foot (23 m) long bridge in Connecticut carrying a road. [1] The second was a railroad bridge over the Connecticut River in Springfield, Massachusetts. This bridge, which drew extensive praise and attention, [3] had seven spans and was 180 feet (55 m) in length. [1] Both bridges were erected ...
The king post is the central, vertical member of the truss. Crown posts in the nave roof at Old Romney church, Kent, England. A king post (or king-post or kingpost) is a central vertical post used in architectural or bridge designs, working in tension to support a beam below from a truss apex above (whereas a crown post, though visually similar, supports items above from the beam below).
A hammer-beam is a form of timber roof truss, allowing a hammerbeam roof to span greater than the length of any individual piece of timber.In place of a normal tie beam spanning the entire width of the roof, short beams – the hammer beams – are supported by curved braces from the wall, and hammer posts or arch-braces are built on top to support the rafters and typically a collar beam.
For more truss types, see truss types used in bridges. A large timber Howe truss in a commercial building. There are two basic types of truss: The pitched truss, or common truss, is characterized by its triangular shape. It is most often used for roof construction. Some common trusses are named according to their "web configuration".
The Tomlinson Lumber Co sold pre-cut materials for a 34 by 50 feet (10 m × 15 m) dairy barn with a Gothic-arched roof supported by three-ply rafters in 1958 throughout Minnesota. [10] The first published plans by an architect for a Gothic-arch barn appeared in 1916. [5]
Interior of a barn with a Fink truss, with the characteristic W shape. Fink design trusses are used today for pedestrian bridges and as roof trusses in building construction in an inverted (upside down) form where the lower chord is present and a central upward projecting vertical member and attached diagonals provide the bases for roofing. [9]