enow.com Web Search

Search results

1. Results from the WOW.Com Content Network

2. Spring pin - Wikipedia

   en.wikipedia.org/wiki/Spring_pin

   A spring pin (also called tension pin or roll pin) is a mechanical fastener that secures the position of two or more parts of a machine relative to each other. Spring pins have a body diameter which is larger than the diameter of the hole they are intended for, and a chamfer on either one or both ends to facilitate starting the pin into the hole.

3. Punch (tool) - Wikipedia

   en.wikipedia.org/wiki/Punch_(tool)

   Roll pin punches are designed with a small projection in the center of the pin tip to support the circumference of the roll pin. The tips of roll pin punches are not flat and should never be used on regular solid pins. If a roll pin punch is used on a solid pin, it will mar or mark the pin. If the end of a roll pin punch is damaged or deformed ...

4. Types of press tools - Wikipedia

   en.wikipedia.org/wiki/Types_of_press_tools

   The compound tool differs from progressive and stage tools by the arrangement of the punch and die. It is an inverted tool where blanking and piercing takes place in a single stage and also the blanking punch will act as the piercing die. That means punch will be to the bottom side of the tool and piercing punches to top side of the tool.

5. Automatic center punch - Wikipedia

   en.wikipedia.org/wiki/Automatic_center_punch

   Green is punch, red is hammer, and blue is trigger slide block. The Adell and Starrett mechanism uses a sliding block crosswise through the hammer rather than an intermediate pin. The hammer has a hole through its center that the top of the punch sits in, and holds the top of the punch centered.

6. Die (manufacturing) - Wikipedia

   en.wikipedia.org/wiki/Die_(manufacturing)

   Compound die: A type of die that has the die block (matrix) mounted on a punch plate with perforators in the upper die with the inner punch mounted in the lower die set. An inverted type of blanking dies that punches upwards, leaving the part sitting on the lower punch (after being shed from the upper matrix on the press return stroke) instead ...

7. Blanking and piercing - Wikipedia

   en.wikipedia.org/wiki/Blanking_and_piercing

   Normally lancing is done on a mechanical press, lancing requires the use of punches and dies to be used. The different punches and dies determine the shape and angle (or curvature) of the newly made section of the material. The dies and punches are needed to be made of tool steel to withstand the repetitious nature of the procedure. [2]

8. Stamping (metalworking) - Wikipedia

   en.wikipedia.org/wiki/Stamping_(metalworking)

   Animation of a power press with a fixed barrier guard. Stamping (also known as pressing) is the process of placing flat sheet metal in either blank or coil form into a stamping press where a tool and die surface forms the metal into a net shape.

9. Engineering drawing abbreviations and symbols - Wikipedia

   en.wikipedia.org/wiki/Engineering_drawing...

   CAD: computer-aided design, computer-aided drafting; cadmium [plating]: CAGE: Commercial and Government Entity [code]: A CAGE code is a unique identifier to label an entity (that is, a specific government agency or corporation at a specific site) that is a CDA, ODA, or MFR of the part defined by the drawing.