Search results
Results from the WOW.Com Content Network
In double track territory one may find two signals mounted side by side on a bracket which itself is mounted on a post. The left hand signal then controls the left-hand track, and the right signal the right-hand track. A gantry or signal bridge may also be used. This consists of a platform extending over the tracks; the signals are mounted on ...
Current diesel engine design allows both left- and right-hand siting. Signals are most commonly mounted on trackside masts about 12 to 15 feet (3.7 to 4.6 m) high to put them in the eyeline of the engineer. Signals can also be mounted on signal bridges or cantilever masts spanning multiple tracks.
The tuned circuit often incorporates the circuit to either apply the transmitted signal to the track or recover the received signal from the other end of the section. Consider a railway with two block sections as in the diagram. Section 1 has frequency A injected at the left-hand end and received at the right-hand end.
The set of rules and the physical equipment used to accomplish this determine what is known as the method of working (UK), method of operation (US) or safe-working (Aus.). Not all these methods require the use of physical signals, and some systems are specific to single-track railways. The earliest rail cars were hauled by horses or mules.
For convenience in passing it from hand to hand, the token was often in the form of a staff, typically 800 mm (31 in) long and 40 mm (1.6 in) diameter, and is referred to as a train staff. [4] Such a staff is usually literally a wooden staff with a brass plate stating the two signal boxes between which it is valid.
In any given country, rail traffic generally runs to one side of a double-track line, not always the same side as road traffic. Thus in Belgium, China, France (apart from the classic lines of the former German Alsace and Lorraine), Sweden (apart from Malmö and further south), Switzerland, Italy and Portugal for example, the railways use left-hand running, while the roads use right-hand running.
It is a Midland Railway signal box dating from 1899, although the original mechanical lever frame has been replaced by electrical switches. Seen here in 2009. Seen here in 2009. On a rail transport system, signalling control is the process by which control is exercised over train movements by way of railway signals and block systems to ensure ...
A signal with associated trip arm in the raised position (circled) Part of a railway signalling system, a train stop, trip stop or tripcock (sometimes called a tripper) is a train protection device that automatically stops a train if it attempts to pass a signal when the signal aspect and operating rules prohibit such movement, or (in some applications) if it attempts to pass at an excessive ...