Search results
Results from the WOW.Com Content Network
The official spelling litre is used in most English-speaking nations; the notable exception is the United States where the spelling liter is preferred. The United States measures weight in pounds (avoirdupois), while recipes in the UK tend to include both imperial and metric measures, following the advice of the Guild of Food Writers. [6]
It is equivalent to the units gram per millilitre (g/mL) and kilogram per litre (kg/L). The density of water is about 1 g/cm 3 , since the gram was originally defined as the mass of one cubic centimetre of water at its maximum density at 4 °C (39 °F).
The fuel consumption is an equivalent measure for cars sold outside the United States, typically measured in litres per 100 km traveled; in general, the fuel consumption and miles per gallon would be reciprocals with appropriate conversion factors, but because different countries use different driving cycles to measure fuel consumption, fuel ...
One litre is about 5.7% larger than a US liquid quart, and about 12% smaller than an imperial quart. A mnemonic for its volume relative to an imperial pint is "a litre of water's a pint and three-quarters"; this is very close, as a litre is about 1.760 imperial pints. A cubic foot has a volume of exactly 28.316 846 592 L.
For example, the freezing point of water is 0 °C and 32 °F, and a 5 °C change is the same as a 9 °F change. Thus, to convert from units of Fahrenheit to units of Celsius, one subtracts 32 °F (the offset from the point of reference), divides by 9 °F and multiplies by 5 °C (scales by the ratio of units), and adds 0 °C (the offset from the ...
Taiwan, like Korea, saw its traditional units standardized to Japanese values and their conversion to a metric basis, such as the Taiwanese ping of about 3.306 m 2 based on the square ken. The Hong Kong SAR continues to use its traditional units, now legally defined based on a local equation with metric units.
Metric regions commonly use the tonne of oil equivalent (toe), or more often million toe (Mtoe). Since this is a measurement of mass, any conversion to barrels of oil equivalent depends on the density of the oil in question, as well as the energy content. Typically 1 tonne of oil has a volume of 1.08 to 1.19 cubic metres (6.8 to 7.5 bbl).
In the oil industry, mud weight is the density of the drilling fluid and is normally measured in pounds per gallon (lb/gal) (ppg) or pound cubic feet (pcf) . [1] In the field it is measured using a mud scale or mud balance. Mud can weigh up to 22 or 23 ppg. A gallon of water typically weighs 8.33 pounds (or 7.48 ppg).