Search results
Results from the WOW.Com Content Network
In computer networking, a media access control attack or MAC flooding is a technique employed to compromise the security of network switches.The attack works by forcing legitimate MAC table contents out of the switch and forcing a unicast flooding behavior potentially sending sensitive information to portions of the network where it is not normally intended to go.
Now, as with any other overlay network protocol, its scalability is tied into how well it can handle the Broadcast, Unknown unicast and Multicast (BUM). [14] In Data Plane Learning the broadcast traffic is flooded to multicast group members. In Control Plane Learning addresses are collected and forwarded via BGP. Broadcast traffic is reduced ...
An overwhelmed network node can send a pause frame, which halts the transmission of the sender for a specified period of time. A media access control (MAC) frame (EtherType 0x8808) is used to carry the pause command, with the Control opcode set to 0x0001 (hexadecimal). [1] Only stations configured for full-duplex operation may send pause frames.
The Individual Address Block (IAB) is an inactive registry which has been replaced by the MA-S (MAC address block, small), previously named OUI-36, and has no overlaps in addresses with the IAB [6] registry product as of January 1, 2014. The IAB uses an OUI from the MA-L (MAC address block, large) registry, previously called the OUI registry.
In computer networking, a unicast flood occurs when a switch receives a unicast frame and the switch does not know that the addressee is on any particular switch port. Since the switch has no information regarding which port, if any, the addressee might be reached through, it forwards the frame through all ports aside from the one through which the frame was received.
A broadcast address is a network address used to transmit to all devices connected to a multiple-access communications network. A message sent to a broadcast address may be received by all network-attached hosts. In contrast, a multicast address is used to address a specific group of devices, and a unicast address is used to address a single ...
ICMP is part of the Internet protocol suite as defined in RFC 792. ICMP messages are typically used for diagnostic or control purposes or generated in response to errors in IP operations (as specified in RFC 1122). ICMP errors are directed to the source IP address of the originating packet. [3]
Wireshark is very similar to tcpdump, but has a graphical front-end and integrated sorting and filtering options.. Wireshark lets the user put network interface controllers into promiscuous mode (if supported by the network interface controller), so they can see all the traffic visible on that interface including unicast traffic not sent to that network interface controller's MAC address.