Search results
Results from the WOW.Com Content Network
One can also find valves with Teflon spindle (for example one way valves or angled valves) When the plug is made of glass, the handle and plug are fused together in one piece out of glass. When both valve body and plug are made of glass, a suitable grease (e.g. silicone grease or Ramsay grease ) is usually used to give a good seal, as well as ...
A petcock is a small shut-off valve used to control the flow of liquid or gas.Historically, petcocks were threaded valves controlled by a butterfly handle; [citation needed] modern petcocks are typically ball valves.
When the handle of a flush toilet with a tank (British, cistern) is turned, a discharge mechanism is activated by means of a rod or chain. The mechanism may be a flapper valve, which is designed to sink more slowly than the water - allowing the water to exit to the toilet bowl below, so that the tank may empty.
An overhead valve engine, abbreviated (OHV) and sometimes called a pushrod engine, is a piston engine whose valves are located in the cylinder head above the combustion chamber. This contrasts with flathead (or "sidevalve") engines , where the valves were located below the combustion chamber in the engine block .
The inside of an extremely large butterfly valve Duplex ball valve Three check valves in corrosion-resistant Hastelloy Stainless steel gate valve. Valves can be categorized into the following types, based on their operating mechanism: Ball valve, for on–off control without pressure drop. Ideal for quick shut-off, since a 90° turn completely ...
A crossflow T-head sidevalve engine The usual L-head arrangement Pop-up pistons may be used to increase compression ratio Flathead with Ricardo's turbulent head. A flathead engine, also known as a sidevalve engine [1] [2] or valve-in-block engine, is an internal combustion engine with its poppet valves contained within the engine block, instead of in the cylinder head, as in an overhead valve ...
A Block and bleed manifold is a hydraulic manifold that combines one or more block/isolate valves, usually ball valves, and one or more bleed/vent valves, usually ball or needle valves, into one component for interface with other components (pressure measurement transmitters, gauges, switches, etc.) of a hydraulic system. The purpose of the ...
The throttle on a gasoline engine is typically a butterfly valve. In a fuel-injected engine, the throttle valve is placed on the entrance of the intake manifold, or housed in the throttle body. In a carbureted engine, it is found in the carburetor. When a throttle is wide open, the intake manifold is usually close to ambient atmospheric pressure.