Search results
Results from the WOW.Com Content Network
A sieve analysis (or gradation test) is a practice or procedure used in geology, civil engineering, [1] and chemical engineering [2] to assess the particle size distribution (also called gradation) of a granular material by allowing the material to pass through a series of sieves of progressively smaller mesh size and weighing the amount of material that is stopped by each sieve as a fraction ...
The mount consists of a bipod and a base plate, which is provided with screw-type elevating and traversing mechanisms to elevate/traverse the mortar. The M64A1 sight unit is attached to the bipod mount. The mortar can be fired in the conventional mode or the handheld mode.
Pressure grouting can be low pressure or high pressure. "Jet grouting" is a general term used for high pressure grouting where the high pressure air, water and cementing grout are injected into the ground at high velocity. This can be doing with single tube systems to mix the grout with in situ soil to form a grouted "column" in the ground.
Non-shrink grout being applied to tiles. Non-shrink grout is a hydraulic cement grout that, when hardened under stipulated test conditions, does not shrink, so its final volume is greater than or equal to the original installed volume. It is often used as a transfer medium between load-bearing members.
Grout sealer is a water-based or solvent-based sealant applied over dried grout that resists water, oil, and acid-based contaminants. Grout cleaner is a basic cleaning solution that is applied on grout lines and removes the dirt and dust. [9] A die grinder is used for faster removal of old grout compared to a standard grout saw.
Pressure grouting or jet grouting [1] involves injecting a grout material into otherwise inaccessible but interconnected pore or void space of which neither the configuration or volume are known, and is often referred to simply as grouting. The grout may be a cementitious, resinous, or solution chemical mixture. Some types of injected grout may ...
Gusset plates are usually square or rectangular, but can be triangular or made into a customized shape to fit the joint. The shape of each plate is designed so that welding or bolts can be applied to different edges of the plate. [2] A gusset plate can form the entire connection or it can be used in conjunction with bolts or welds. [2]
The mortar squad leader verifies the number of charges; then the assistant gunner drops the round down the muzzle of the tube. The round, pulled by gravity, accelerates down the smooth bore of the mortar until the primer (in the base of the tail boom of the round) strikes the firing pin located in the bottom of the mortar tail assembly. The ...