Search results
Results from the WOW.Com Content Network
Figure 3: A current amplifier (gray box) driven by a Norton source (i S, R S) and with a resistor load R L. Current divider in blue box at input (R S, R in) reduces the current gain, as does the current divider in green box at the output (R out,R L) The gain of an amplifier generally depends on its source and load terminations.
A series circuit with a voltage source (such as a battery, or in this case a cell) and three resistance units. Two-terminal components and electrical networks can be connected in series or parallel. The resulting electrical network will have two terminals, and itself can participate in a series or parallel topology.
Voltage divider or potential divider is used for circuits of that purpose. L-section is a common name for the topology in filter design. A network with three branches has four possible topologies. Figure 1.4. Series and parallel topologies with three branches. Note that the parallel-series topology is another representation of the Delta ...
In direct-current circuit theory, Norton's theorem, also called the Mayer–Norton theorem, is a simplification that can be applied to networks made of linear time-invariant resistances, voltage sources, and current sources. At a pair of terminals of the network, it can be replaced by a current source and a single resistor in parallel.
Parallel RL circuit. When both the resistor and the inductor are connected in parallel connection and supplied through a voltage source, this is known as a RL parallel circuit. [2] The parallel RL circuit is generally of less interest than the series circuit unless fed by a current source.
Figure 1: A simple voltage divider. A voltage divider referenced to ground is created by connecting two electrical impedances in series, as shown in Figure 1. The input voltage is applied across the series impedances Z 1 and Z 2 and the output is the voltage across Z 2.
Series RL, parallel C circuit with resistance in series with the inductor is the standard model for a self-resonant inductor. A series resistor with the inductor in a parallel LC circuit as shown in Figure 4 is a topology commonly encountered where there is a need to take into account the resistance of the coil winding and its self-capacitance.
Source transformations are easy to compute using Ohm's law.If there is a voltage source in series with an impedance, it is possible to find the value of the equivalent current source in parallel with the impedance by dividing the value of the voltage source by the value of the impedance.