Search results
Results from the WOW.Com Content Network
If a gaseous emission sample is analyzed and found to contain water vapor and a pollutant concentration of say 40 ppmv, then 40 ppmv should be designated as the "wet basis" pollutant concentration. The following equation can be used to correct the measured "wet basis" concentration to a "dry basis" concentration: [3]
Superheating can occur when an undisturbed container of water is heated in a microwave oven.At the time the container is removed, the lack of nucleation sites prevents boiling, leaving the surface calm.
The term subcooling (also called undercooling) refers to the intentional process of cooling a liquid below its normal boiling point. For example, water boils at 373 K; at room temperature (293 K) liquid water is termed "subcooled". Subcooling is a common stage in refrigeration cycles and steam turbine cycles.
Supercooled water, still in liquid state Start of solidification as a result of leaving the state of rest. Supercooling, [1] also known as undercooling, [2] [3] is the process of lowering the temperature of a liquid below its freezing point without it becoming a solid.
Engineering Equation Solver (EES) is a commercial software package used for solution of systems of simultaneous non-linear equations.It provides many useful specialized functions and equations for the solution of thermodynamics and heat transfer problems, making it a useful and widely used program for mechanical engineers working in these fields.
The incorporation of a subcooling stage after the receiver reduces even more the chances to observe flash gas. [5] This subcooling may be done in a reserved portion of the main condenser, or separately with a heat exchanger. Some receivers may incorporate an internal heat exchanger that draws heat form the subcooled liquid to superheat the gas ...
The heat pump itself can be improved by increasing the size of the internal heat exchangers, which in turn increases the efficiency (and the cost) relative to the power of the compressor, and also by reducing the system's internal temperature gap over the compressor. Obviously, this latter measure makes some heat pumps unsuitable to produce ...
The enthalpy difference required for the subcooling leads to the superheating of the vapor drawn into the compressor. When the increase in cooling achieved by subcooling is greater that the compressor drive input required to overcome the additional pressure losses, such a heat exchange improves the coefficient of performance. [66]