Search results
Results from the WOW.Com Content Network
Trigger guard of a SG 550 rifle. A trigger guard is a protective loop surrounding the trigger of a firearm designed to prevent unwanted contact with the trigger, which may cause an accidental discharge. [1] Other devices that use a trigger-like actuator mechanism, such as inhalers, crossbows and power tools, may also have trigger guards.
The user selects the operating mode with a large side lever on the left side of the trigger pack that can be rotated to select S (safe), E (semi-automatic fire) or M (full-automatic fire). On the right hand side of the rifle, there is a foldaway 'winter' trigger which enables the operator to use the rifle with arctic mittens.
A hell-fire trigger is a device that allows a semi-automatic firearm to fire at an increased rate. The hell-fire clamps to the trigger guard behind the trigger and presses a "finger" against the back of the trigger to increase the force that returns the trigger to its forward position, effectively decreasing the time required for the trigger to reset, allowing for a faster follow-up shot.
A trigger disconnector captures the hammer in the cocked position after a shot has been fired, even if the trigger is held to the rear as the gun cycles. This ensures the gun can only fire in the semi-automatic mode, as the trigger needs to be released to 'reset' and have the disconnector release the hammer back to the trigger sear.
A forced reset trigger (or "hard reset" trigger) is a device that allows a person to fire a semi-automatic firearm at an increased rate. The forced reset trigger works by mechanically resetting the trigger's position after a shot is fired. This allows for an increased rate of fire.
A disassembled Mauser action showing a partially disassembled receiver and bolt. In firearms terminology and law, the firearm frame or receiver is the part of a firearm which integrates other components by providing housing for internal action components such as the hammer, bolt or breechblock, firing pin and extractor, and has threaded interfaces for externally attaching ("receiving ...
Upon the command make ready the musket was brought to the recover position (held vertically in front of the body with the trigger guard facing forward) and the cock (hammer) was drawn back to the full-cock position. Upon the command "P'sent" (present) the musket was brought up to the firing position in anticipation of the command fire.
The release was the final package in a string of multiple smaller releases, which included the improved barrel ECMv2.0 process, and the Menendez Mag v2.0, and the Common Sense Fire Control Group AR-15 printable trigger, all created by Ivan The Troll in preparation for the FGC-9 MkII release. [17]