enow.com Web Search

Search results

1. Results from the WOW.Com Content Network

2. Power electronics - Wikipedia

   en.wikipedia.org/wiki/Power_electronics

   The full-bridge inverter is similar to the half bridge-inverter, but it has an additional leg to connect the neutral point to the load. [17] Figure 3 shows the circuit schematic of the single-phase voltage source full-bridge inverter.

3. H-bridge - Wikipedia

   en.wikipedia.org/wiki/H-bridge

   The arrangement is sometimes known as a single-phase bridge inverter. The H-bridge with a DC supply will generate a square wave voltage waveform across the load. For a purely inductive load, the current waveform would be a triangle wave, with its peak depending on the inductance, switching frequency, and input voltage.

4. Power inverter - Wikipedia

   en.wikipedia.org/wiki/Power_inverter

   In a similar manner, the right topology (full H-bridge) can invert the roles of "source" and "load", that is, if for example the voltage is higher on the AC "load" side (by adding a solar inverter, similar to a gen-set, but solid state), energy can flow back into the DC "source" or battery.

5. Variable-frequency drive - Wikipedia

   en.wikipedia.org/wiki/Variable-frequency_drive

   VSI drives provide higher power factor and lower harmonic distortion than phase-controlled current-source inverter (CSI) and load-commutated inverter (LCI) drives (see 'Generic topologies' sub-section below). The drive controller can also be configured as a phase converter having single-phase converter input and three-phase inverter output. [15]

6. Single-phase electric power - Wikipedia

   en.wikipedia.org/wiki/Single-phase_electric_power

   Single-phase motors may have taps to allow their use on either 208-volt or 240-volt supply. A single-phase load may be powered directly from a three-phase distribution transformer in two ways: by connection between one phase and neutral or by connection between two phases. These two give different voltages from a given supply.

7. HVDC converter - Wikipedia

   en.wikipedia.org/wiki/HVDC_converter

   The basic LCC configuration for HVDC uses a three-phase Graetz bridge rectifier or six-pulse bridge, containing six electronic switches, each connecting one of the three phases to one of the two DC terminals. [12] A complete switching element is usually referred to as a valve, irrespective of its construction. Normally, two valves in the bridge ...