Ad
related to: homemade outboard motor bracket 71091 diagram
Search results
Results from the WOW.Com Content Network
Basic parts of an outboard motor. An outboard motor is a propulsion system for boats, consisting of a self-contained unit that includes engine, gearbox and propeller or jet drive, designed to be affixed to the outside of the transom. They are the most common motorised method of propelling small watercraft.
1927 Johnson Seahorse outboard motor at the Tellus Science Museum. The original company that made Johnson inboard motors and outboard motors was the Johnson Brothers Motor Company of Terre Haute, Indiana, United States. They started building inboard 2-cycle marine engines in 1903 in a barn behind the house, along with matching boats.
The outdrive resembles the bottom half of an outboard motor and is composed of two sub-units: an upper containing a driveshaft connected through the transom to an engine which transmits power to a 90-degree-angle gearbox; and the lower containing a vertical driveshaft receiving power from the upper unit gearbox, transmitted through another 90 ...
Ole Evinrude formed Evinrude Outboard Motors, which he sold in 1913 in order to look after his sick wife. In 1919, Evinrude invented a more efficient and lighter two-cylinder motor. Having sold his part in Clemick & Evinrude, he founded ELTO or the Elto Outboard Motor Company. (ELTO was an acronym for "Evinrude Light Twin Outboard".)
British Seagull was a British manufacturer of simple and rugged two-stroke marine outboard motors, produced from the late 1930s until the mid-1990s. Originally based in Wolverhampton, the company moved to Poole, Dorset, a centre for boating and yachting. Seagull engines were utilitarian outboards with a relatively slow-turning prop.
Outboard Marine Corporation sometimes referred to as Outboard Motor Company was formed in 1929 when ELTO was merged with Lockwood-Ash Motor Company. They began using the name OMC in 1956. Outboard Marine Corporation was the world's largest manufacturer and supplier of outboard motors and second largest producer of powerboats.
Chainplate: a metal bracket through-bolted through the hull for anchoring a shroud. Centreboard: (also dagger board) a movable keel which may be raised and lowered to accommodate shallow water and point of sail. It is held in place within a centerboard trunk. Chine: the part of a hull at the turn of the bilge. It may be "hard" (i.e. sharply ...
The plug is machined to accept a typical bottom bracket, but offset from the center of the plug, so that by rotating the plug, the location of the bottom bracket (and hence the chain tension) may be adjusted (fore and aft to tension the chain, the upper or lower eccentric position for a given chain length can be chosen to fine tune bottom ...
Ad
related to: homemade outboard motor bracket 71091 diagram