Ads
related to: metal rod with flat ends for wall anchors
Search results
Results from the WOW.Com Content Network
A stylized anchor plate in the cloister of the Church of St. Trophime, Arles (France) An anchor plate, floor plate [1] or wall washer is a large plate or washer connected to a tie rod or bolt. Anchor plates are used on exterior walls of masonry buildings, for structural reinforcement against
A tie rod or tie bar (also known as a hanger rod if vertical) is a slender structural unit used as a tie and (in most applications) capable of carrying tensile loads only. It is any rod or bar-shaped structural member designed to prevent the separation of two parts, as in a vehicle. Tie rods and anchor plates in the ruins of Coventry Cathedral
Grouted tiebacks can be constructed as steel rods drilled through a concrete wall out into the soil or bedrock on the other side. Grout is then pumped under pressure into the tieback anchor holes to increase soil resistance and thereby prevent tiebacks from pulling out, reducing the risk for wall destabilization.
A threaded rod, also known as a stud, is a relatively long rod that is threaded on both ends; the thread may extend along the complete length of the rod. [1] They are designed to be used in tension. [2] Threaded rod in bar stock form is often called all-thread (ATR); other names include fully-threaded rod, redi-rod, continuously-threaded rod ...
Reinforcing bars in masonry construction have been used since antiquity, with Rome using iron or wooden rods in arch construction. [5] Iron tie rods and anchor plates were later employed across Medieval Europe, as a device to reinforce arches, vaults, and cupolas. [6] [7] 2,500 meters of rebar was used in the 14th-century Château de Vincennes. [8]
The girt system must be competent and adequately stiff to provide the required stabilizing resistance in addition to its role as a wall panel support. [citation needed] Girts are stabilized by (sag) rods/angles/straps and by the wall cladding. Stabilizing rods are discrete brace members to prevent rotation of an unsupported flange of the girt.
Helical anchors consist of an extendable steel shaft with helical bearing plates. Piles or piers refer to strong base elements that withstand or transfer vertical/horizontal loads. Anchors are piles utilised only in tension applications like restraining wall tiebacks or vertical ground anchors made to resist overturning forces.
A hold down resisting uplift from a timber shear wall. Holdown (holdown, hold-down, or hold down) or tie-down in structural engineering refers to the steel device or hardware that is installed at the end of a plywood shear wall. The hold downs provide uplift resistance against the overturning moment imposed on the wall due to "in-plane" lateral ...
Ads
related to: metal rod with flat ends for wall anchors