Search results
Results from the WOW.Com Content Network
A typical evaporative, forced draft open-loop cooling tower rejecting heat from the condenser water loop of an industrial chiller unit. A cooling tower is a device that rejects waste heat to the atmosphere through the cooling of a coolant stream, usually a water stream, to a lower temperature.
Liquid cooling is also used to remove heat from large buildings by using chillers which transfer the coolant from the evaporator to air handling units, chilled beams and fan coil units inside the building, and to the cooling towers from the condenser if the condenser is liquid-cooled.
Cooling towers are structures for cooling water or other heat transfer media to near-ambient wet-bulb temperature. Wet cooling towers operate on the evaporative cooling principle, but are optimized to cool the water rather than the air. Cooling towers can often be found on large buildings or on industrial sites.
Water cooling. Cooling tower and water discharge of a nuclear power plant. Water cooling is a method of heat removal from components and industrial equipment. Evaporative cooling using water is often more efficient than air cooling. Water is inexpensive and non-toxic; however, it can contain impurities and cause corrosion.
Immersion cooling. Immersion cooling is an IT cooling practice by which complete servers are immersed in a dielectric, electrically non-conductive fluid that has significantly higher thermal conductivity than air. Heat is removed from a system by putting the coolant in direct contact with hot components, and circulating the heated liquid ...
Windcatcher. An ab anbar (water reservoir) with windcatchers (openings near the top of the towers) in the central desert city of Yazd, Iran. Aghazadeh Mansion in Abarkooh, Iran, has an elaborate 18-m windtower with two levels of openings, plus some smaller windtowers. A windcatcher, wind tower, or wind scoop (Persian: بادگیر) is a ...
Computer cooling. A finned air cooled heatsink with fan clipped onto a CPU, with a smaller passive heatsink without fan in the background. A 3-fan heatsink mounted on a video card to maximize cooling efficiency of the GPU and surrounding components. Commodore 128DCR computer's switch-mode power supply, with a user-installed 60 mm cooling fan.
The cooling tower water can be directly linked into the flow through the chilled water circuit. If the cooling tower is open then a strainer is required to eliminate any debris that could accumulate within the tower. The cost savings are associated with the limited use of the water chiller energy. There is an increased risk of corrosion using ...