Search results
Results from the WOW.Com Content Network
The efficacy of fluorescent tubes ranges from about 16 lumens per watt for a 4 watt tube with an ordinary ballast to over 100 lumens per watt [51] with a modern electronic ballast, commonly averaging 50 to 67 lm/W overall. [52] Ballast loss can be about 25% of the lamp power with magnetic ballasts, and around 10% with electronic ballasts.
Original 4–13 W miniature fluorescent range from 1950s or earlier. [1] Two newer ranges, high-efficiency (HE) 14–35 W, and high-output (HO) 24–80 W, introduced in the 1990s. [2] Panasonic's range of FHL fluorescent tubes in 18W, 27W, and 36W varieties for the Japanese market. Circular fluorescent tubes.
Compact fluorescent lamp with GU24 cap. A GU24 lamp fitting is a bi-pin connector for compact fluorescent lamps (CFL) or LED lamps that uses a bayonet mount–like twist-lock bi-pin connector instead of the Edison screw fitting used on many CFLs, LED lamps and incandescent light bulbs.
[1] [3] To prevent this, fluorescent tubes are connected to the power line through a ballast. The ballast adds positive impedance (AC resistance) to the circuit to counteract the negative resistance of the tube, limiting the current. [1] Several American magnetic ballasts for fluorescent lamps. The top is a rapid start series autoregulator ...
A preheat fluorescent lamp circuit using automatic starting switch. A: Fluorescent tube, B: Power (+220 volts), C: Starter, D: Switch (bi-metallic thermostat), E: Capacitor, F: Filaments, G: Ballast. When power is first applied to the circuit, there will be a glow discharge across the electrodes in the starter lamp.
The suffix after the G indicates the pin spread; the G dates to the use of Glass for the original bulbs. GU usually also indicates that the lamp provides a mechanism for physical support by the luminaire: in some cases, each pin has a short section of larger diameter at the end (sometimes described as a "peg" rather than a "pin" [2]); the socket allows the bulb to lock into place by twisting ...
Circular and U-shaped lamps were devised to reduce the length of fluorescent light fixtures. The first fluorescent light bulb and fixture were displayed to the general public at the 1939 New York World's Fair. The spiral CFL was invented in 1976 by Edward E. Hammer, an engineer with General Electric, [7] in response to the 1973 oil crisis. [8]
Fluorescent Linear Tube Light bulbs are measured in 1 ⁄ 8 of inches. So a T12 fluorescent is 12 ⁄ 8 of an inch in diameter or 12 ⁄ 8 = 1.50" T4 – 4/8 or 0.500 in (12.7 mm) in diameter