Ad
related to: gasoline engine throttle position sensor diagram imagesebay.com has been visited by 1M+ users in the past month
- eBay Money Back Guarantee
Worry-Free Shopping.
eBay Is Here For You!
- Electronics
From Game Consoles to Smartphones.
Shop Cutting-Edge Electronics Today
- Home & Garden
From Generators to Rugs to Bedding.
You’ll Find Everything You Need
- Music
Find Your Perfect Sound.
Huge Selection of Musical Gear.
- eBay Money Back Guarantee
Search results
Results from the WOW.Com Content Network
A throttle position sensor (TPS) is a sensor used to monitor the throttle body valve position for the ECU of an engine. The sensor is usually located on the butterfly spindle/shaft, so that it can directly monitor the position of the throttle. More advanced forms of the sensor are also used. For example, an extra "closed throttle position ...
The ECU then increases the amount of fuel injected by the injectors in order to obtain the required air-fuel ratio. Often a throttle position sensor (TPS) is connected to the shaft of the throttle plate to provide the ECU with information on whether the throttle is in the idle position, wide-open throttle (WOT) position, or somewhere in between ...
A typical ETC system consists of three major components: (i) an accelerator pedal module (ideally with two or more independent sensors), (ii) a throttle valve that can be opened and closed by an electric motor (sometimes referred to as an electric or electronic throttle body (ETB)), and (iii) a powertrain or engine control module (PCM or ECM). [4]
The Ford EEC (Electronic Engine Control) system, which utilized the Toshiba TLCS-12 microprocessor, went into mass production in 1975. [ 7 ] The first Bosch engine management system was the Motronic 1.0 , which was introduced in the 1979 BMW 7 Series (E23) [ 8 ] This system was based on the existing Bosch Jetronic fuel injection system, to ...
The actuator consists of a linear servo actuator servomotor that controls a plunger which varies air flow through the throttle body. The position of the servomotor and hence the amount of air bypass is controlled digitally by the engine ECU. This allows the engine's idle speed to be maintained constant.
Therefore, an accelerator pump is often used to briefly provide extra fuel as the throttle is opened. [12] When the driver presses the throttle pedal, a small piston or diaphragm pump injects extra fuel directly into the carburetor throat. [13] The accelerator pump can also be used to "prime" an engine with extra fuel prior to attempting a cold ...
In the US, this kind of single-point injection was marketed as 'throttle body injection' (TBI, by GM), or 'central fuel injection' (CFI, by Ford). Mono-Jetronic is different from all other known single-point systems, in that it only relies on a throttle position sensor for judging the engine load.
Alternatively, a manifold vacuum sensor can be used. The manifold vacuum sensor signal, the throttle position, and the crankshaft speed can then be used by the engine control unit to calculate the correct amount of fuel. In modern engines, a combination of all these systems is used. [5]
Ad
related to: gasoline engine throttle position sensor diagram imagesebay.com has been visited by 1M+ users in the past month