Search results
Results from the WOW.Com Content Network
In jet piling high pressure water is used to set piles. [8] High pressure water cuts through soil with a high-pressure jet flow and allows the pile to be fitted. [9] One advantage of Jet Piling: the water jet lubricates the pile and softens the ground. [10] The method is in use in Norway. [11]
Franki piles can be used as high-capacity deep foundation elements without the necessity of excavation or dewatering. [4] They are useful in conditions where a sufficient bearing soil can only be reached deeper in the ground, [5] [6] and are best suited to granular soil where bearing is primarily achieved from the densification of the soil around the base. [4]
Tracked vehicle configured as a dedicated pile driver. A pile driver is a heavy-duty tool used to drive piles into soil to build piers, bridges, cofferdams, and other "pole" supported structures, and patterns of pilings as part of permanent deep foundations for buildings or other structures. Pilings may be made of wood, solid steel, or tubular ...
Pressure piling is a phenomenon related to combustion of gases in a tube or long vessel. When a flame front propagates along a tube, the unburned gases ahead of the front are compressed, and hence heated. The amount of compression varies depending on the geometry and can range from twice to eight times the initial pressure.
Screw foundations first appeared in the 1800s as pile foundations for lighthouses, [3] and were extensively used for piers in harbours. Between the 1850s through 1890s, more than 100 screw-pile lighthouses were erected on the east coast of the United States using screw piles. Made originally from cast or wrought iron, they had limited bearing ...
Larssen sheet piling is a kind of sheet piling retaining wall.Segments with indented profiles (troughs) interlock to form a wall with alternating indents and outdents. The troughs increase resistance to bending.
Hydraulic systems use high fluid pressure, such as the hydraulic actuators for bulldozers and backhoes. Their hydraulic fittings are designed and rated for much greater pressure than that experienced in general piping systems, and they are generally not compatible with those used in plumbing.
A continuous flight auger drill is used to excavate a hole and concrete is injected through a hollow shaft under pressure as the auger is extracted. Reinforcement is then inserted after the auger is removed. [1] This creates a continuous pile without ever leaving an open hole.