Search results
Results from the WOW.Com Content Network
NATO Accessory Rail (STANAG 4694) The NATO Accessory Rail (NAR), defined by NATO Standardization Agreement (STANAG) 4694, is a rail interface system standard for mounting accessory equipment such as telescopic sights, tactical lights, laser aiming modules, night vision devices, reflex sights, foregrips, bipods and bayonets to small arms such as rifles and pistols.
The only significant difference between the MIL-STD-1913 rail and the similar Weaver rail mount are the size and shapes of the slots. Whereas the earlier Weaver rail is modified from a low, wide dovetail rail and has rounded slots, the 1913 rail has a more pronounced angular section and square-bottomed slots. This means that an accessory ...
A rail system mounted on top of a SIG SG 550 A dovetail rail on a rifle receiver for mounting a sight. A rail integration system (RIS; also called a rail accessory system (RAS), rail interface system, rail system, mount, base, gun rail, or simply a rail [1]) is a generic term for any standardized attachment system for mounting firearm accessories via bar-like straight brackets (i.e. "rails ...
The terms rail anchors, tie plates, chairs and track fasteners are used to refer to parts or all of a rail fastening system. The components of a rail fastening system may also be known collectively as other track material, or OTM for short. Various types of fastening have been used over the years.
The Picatinny rail has a similar profile to the Weaver, but the recoil groove width of the Picatinny rail is 0.206 in (5.23 mm) versus 0.180 in (4.57 mm) of the Weaver rail/mount, and by contrast with the Weaver, the spacing of the Picatinny recoil groove centers is consistent, at 0.394 in (10.01 mm). [5]
[citation needed] Compatible scopes have an internal dovetail rail where two or more 45-degree wedge nuts can be slid in. For example, EAW uses wedge nuts with M5 or M4 threads. [11] The scope mount is then attached using simple hand tools like a torx key or hex key to a torque between 4–5 N⋅m (3.0–3.7 lbf⋅ft). [12]
The M-LOK rail specification included metric dimensions instead of imperial, and utilizes a T-slot nut capable of only 90-degree rotation, reinforced by thread-locking fluid, making it suited for applications on free-floating handguards. It was designed to work with both metal and polymer parts.
Angles are measured using a sine bar with the help of gauge blocks and a dial gauge or a spirit level. The aim of a measurement is to measure the surface on which the dial gauge or spirit level is placed horizontally. For example, to measure the angle of a wedge, the wedge is placed on a horizontal table. The sine bar is placed over the ...