enow.com Web Search

  1. Ads

    related to: floor mounted dimmer switch diagram led driver control button 4 pin

Search results

  1. Results from the WOW.Com Content Network
  2. Light switch - Wikipedia

    en.wikipedia.org/wiki/Light_switch

    Two light switches in one box. The switch on the right is a dimmer switch. The switch box is covered by a decorative plate. The first light switch employing "quick-break technology" was invented by John Henry Holmes in 1884 in the Shieldfield district of Newcastle upon Tyne. [1]

  3. Dimmer - Wikipedia

    en.wikipedia.org/wiki/Dimmer

    They enable computer control via networked switches, but do not require it. Their cost is about the same as the older "dimmability" circuitry that they replace in LED bulbs, fixtures or drivers. A residential-type dimmer switch with sliding knob to change brightness. The device is small enough to fit into a regular wall box provided for a switch.

  4. Stage pin connector - Wikipedia

    en.wikipedia.org/wiki/Stage_pin_connector

    A newer stage pin connector. Note the GR denoting the longer ground pin, which is slightly off-center to prevent the plug being inserted upside down.. A stage pin connector, also known as a grounded stage pin (GSP), grounded pin connector (GPC) or theater paddle (TP), is a standard cable type for theatrical lighting in North America and in many countries in the theatre world.

  5. LED circuit - Wikipedia

    en.wikipedia.org/wiki/LED_circuit

    In CC drivers, the voltage changes while the current stays the same. CC drivers are used when the electrical load of the LED circuit is either unknown or fluctuates, for example, a lighting circuit where a variable number of LED lamp fixtures may be installed. As an LED heats up, its voltage drop decreases (band gap decrease [1]). This can ...

  6. 0-10 V lighting control - Wikipedia

    en.wikipedia.org/wiki/0-10_V_lighting_control

    The switch is controlled by a PWM (Pulse Width Modulation) signal, which alternately turns the switch on and off at a rapid rate. The relative proportion of off time vs. on time determines brightness. For example, if the switch is off 10% of the time, the resulting control signal would be the equivalent of 1 V produced with a variable resistor.

  7. Automotive lighting - Wikipedia

    en.wikipedia.org/wiki/Automotive_lighting

    This type of convenience lighting approach is also sometimes used to illuminate interior or exterior door handles, exterior step running boards, or electric window switches. LED light sources appear increasingly as interior convenience lights in various locations, especially with finely focused lighting on console control surfaces and in cabin ...

  1. Ads

    related to: floor mounted dimmer switch diagram led driver control button 4 pin