Search results
Results from the WOW.Com Content Network
The Video Graphics Array (VGA) connector is a standard connector used for computer video output. Originating with the 1987 IBM PS/2 and its VGA graphics system, the 15-pin connector went on to become ubiquitous on PCs, [ 1 ] as well as many monitors, projectors and HD television sets.
D-subminiature connectors are often used in industrial products, the DA-15 version being commonly used on rotary and linear encoders. DB-19 connector for an external floppy drive on a Macintosh 512K. The early Macintosh and late Apple II computers used a non-standard 19-pin D-sub for connecting external floppy disk drives.
An AUI connector is a DA-15 (D-subminiature) type, where the DTE side has a female connector and the MAU side has a male connector. [1]The connector often uses a sliding clip instead of the typical thumbscrews found on D-connectors, allowing the DTE and MAU to be directly attached, even when their size or shape would not accommodate thumbscrews.
Pin 1 is typically indicated on the body of the connector by a red or raised "V" mark. The corresponding wire in a ribbon cable is usually indicated by red coloration, a raised molded ridge, or markings printed onto the cable insulation. On the connector pin 2 is opposite pin 1, pin 3 is next to pin 1 along the length of the connector, and so on.
DataSheets.com is a searchable database of electronic component data sheets and purchasing information. [1] The website is intended for Design engineers and Electronics purchasing agents. [ 2 ] DataSheets.com was developed by UBM in conjunction with SiliconExpert Technologies .
The vampire tap usually had an integrated AUI (Attachment Unit Interface) in the form of a DA-15 connector, from which a short multicore cable connected to the network card in the station (host computer). Vampire taps allowed new connections to be made on a given physical cable while the cable was in use.
It is very common in blogs and websites to incorrectly name a specific connector only by the name of the manufacturer. To minimize confusion, it is best to describe a connector using: the manufacturer's name, exact connector series, and optionally the pitch, such as "JST-XH" or "JST-XH-2.50mm" or "2.50mm JST XH-series" or other variations.
1×6 pin header (one row) 1×6 female header (one row) A pin header (or simply, header) is a form of electrical connector.A male pin header consists of one or more rows of metal pins molded into a plastic base, often 2.54 mm (0.1 in) apart, though available in many spacings. [1]