Search results
Results from the WOW.Com Content Network
The taper rate for all NPT threads is 1 inch of diameter in 16 inches of length (3 ⁄ 4 inch per foot or 62.5 millimeters per meter) measured by the change of diameter (of the pipe thread) over distance of thread.
Conversion of units is the conversion of the unit of measurement in which a quantity is expressed, typically through a multiplicative conversion factor that changes the unit without changing the quantity. This is also often loosely taken to include replacement of a quantity with a corresponding quantity that describes the same physical property.
In the modern standard metric version, it is simply a size number, where listed diameter size is the major outer diameter of the external thread. For a taper thread, it is the diameter at the "gauge length" (plus/minus one thread pitch) from the small end of the thread.
The legislation states that the federal government has a responsibility to assist industry, especially small business, as it voluntarily converts to the metric system of measurement. The legislation required most federal agencies to use the metric system in their procurement, grants, and other business-related activities by the end of 1992. [26]
Metric units are units based on the metre, gram or second and decimal (power of ten) multiples or sub-multiples of these. According to Schadow and McDonald, [ 1 ] metric units, in general, are those units "defined 'in the spirit' of the metric system, that emerged in late 18th century France and was rapidly adopted by scientists and engineers.
The International System of Units is the modern metric system. It is based on the metre–kilogram–second–ampere (MKSA) system of units from early in the 20th century. [20] It also includes numerous coherent derived units for common quantities like power (watt) and irradience (lumen).
Mesures usuelles (French for customary measures) were a system of measurement introduced as a compromise between the metric system and traditional measurements. It was used in France from 1812 to 1839. A number of variations on the metric system have been in use.
The major diameter still extends to within 1 / 8 H of the theoretical sharp V, but the total depth of the thread is reduced 4% from 5 / 8 H = 5 / 8 cos(30°) P ≈ 0.541P to 0.52P. [5] This increases the amount of the theoretical sharp V which is cut off at the minor diameter by 10% from 0.25H to 7 / 8 − 0. ...