Search results
Results from the WOW.Com Content Network
The Metric Conversion Act of 1975 is an Act of Congress that was signed into law by U.S. President Gerald Ford on December 23, 1975. [1] It declared the metric system "the preferred system of weights and measures for United States trade and commerce", but permitted the use of United States customary units in all activities.
The taper rate for all NPT threads is 1 inch of diameter in 16 inches of length (3 ⁄ 4 inch per foot or 62.5 millimeters per meter) measured by the change of diameter (of the pipe thread) over distance of thread.
The legislation required most federal agencies to use the metric system in their procurement, grants, and other business-related activities by the end of 1992. [26] While not mandating metric use in the private sector, the federal government has sought to serve as a catalyst in the metric conversion of the country's trade, industry, and commerce.
At the First United States Congress, which met in 1789 when the decimal metric system had not yet been developed in France, the system of units to be used in the U.S. was one point of discussion. Under the Constitution (article I, section 8), the Congress has the constitutional right to decide on a standard of weights and measures.
The Metric Act of 1866, also known as the Kasson Act, is a piece of United States legislation that legally protected use of the metric system in commerce from lawsuit, and provided an official conversion table from United States customary units. [1]
The United States Metric Board (USMB) was a United States government agency set up to encourage metrication. The United States Metric Board was commissioned by the Metric Conversion Act of 1975 (15 U.S.C. 205d, enacted on December 23, 1975). The Metric Conversion Act of 1975 mandated the presidential appointment of seventeen members for the ...
For example, AN6 bolt has a 3 ⁄ 8-24 thread [3] whereas an -6 AN fitting has a 9 ⁄ 16-18 thread. [ 4 ] Originally parts were made compliant to the specification MIL-F-5509, but they are now controlled under SAE AS (Aerospace Standards) specifications AS4841 through AS4843 and AS4875.
It adopted the standards of the metric system and redefined the yard, pound, gallon, and bushel in terms of metric units. The Metric Conversion Act of 1975 started a voluntary metrication process in the US and, as amended by the Omnibus Foreign Trade and Competitiveness Act of 1988, declared the metric system to be "the preferred system of ...