Search results
Results from the WOW.Com Content Network
In geotechnical engineering, soil compaction is the process in which stress applied to a soil causes densification as air is displaced from the pores between the soil grains. When stress is applied that causes densification due to water (or other liquid) being displaced from between the soil grains, then consolidation , not compaction, has ...
Soil bulk density is equal to the dry mass of the soil divided by the volume of the soil; i.e., it includes air space and organic materials of the soil volume. Thereby soil bulk density is always less than soil particle density and is a good indicator of soil compaction. [47] The soil bulk density of cultivated loam is about 1.1 to 1.4 g/cm 3 ...
One approximate relationship between SPT N-value, relative density, and bulk density for coarse-grained material can be seen in the table below. This is cited in the US Army Corps of Engineers engineering manual publication on sheet pile design developed after Terzaghi and Peck (1948) and Teng (1962). [2]
Relative density a measure of the current void ratio in relation to the maximum and minimum void rations, and applied effective stress control the mechanical behavior of cohesionless soil. Relative density is defined by = % in which ,, and are the maximum, minimum and actual void rations.
The Proctor compaction test is a laboratory method of experimentally determining the optimal moisture content at which a given soil type will become most dense and achieve its maximum dry density. The test is named in honor of Ralph Roscoe Proctor [ de ] , who in 1933 showed that the dry density of a soil for a given compactive effort depends ...
If the soil particles in a sample are predominantly in a relatively narrow range of sizes, the sample is uniformly graded. If a soil sample has distinct gaps in the gradation curve, e.g., a mixture of gravel and fine sand, with no coarse sand, the sample may be gap graded. Uniformly graded and gap graded soils are both considered to be poorly ...
The bulk density of soil depends greatly on the mineral make up of soil and the degree of compaction. [3] The density of quartz is around 2.65 g/cm 3 but the (dry) bulk density of a mineral soil is normally about half that density, between 1.0 and 1.6 g/cm 3.
Soil bulk density, when determined at standardized moisture conditions, is an estimate of soil compaction. [60] Soil porosity consists of the void part of the soil volume and is occupied by gases or water. Soil consistency is the ability of soil materials to stick together. Soil temperature and colour are self-defining.