Search results
Results from the WOW.Com Content Network
A reference to a memory location includes a value that identifies a segment and an offset within that segment. A segment descriptor may limit access rights, e.g., read only, only from certain rings. The x86 architecture has multiple segmentation features, which are helpful for using protected memory on this architecture. [1]
The memory controller can begin a read from the second bank while a read from the first bank is in progress, using the two OE signals to only permit one result to appear on the data bus at a time. RAS-only refresh
Memory bandwidth is the rate at which data can be read from or stored into a semiconductor memory by a processor. Memory bandwidth is usually expressed in units of bytes/second , though this can vary for systems with natural data sizes that are not a multiple of the commonly used 8-bit bytes.
Exploiting these flaws is complex but programming errors in Wi-Fi products are easier to exploit. Despite improvements in Wi-Fi security, these findings highlight the need for continuous security analysis and updates. In response, security patches were developed, and users are advised to use HTTPS and install available updates for protection. [59]
MemTest86 and Memtest86+ are memory test software programs designed to test and stress test an x86 architecture computer's random-access memory (RAM) for errors, by writing test patterns to most memory addresses, reading back the data, and comparing for errors. [6]
Using active techniques like Wi-Fi deauthentication attacks and ARP re-injection, 40,000 packets can be captured in less than one minute under good conditions. The actual computation takes about 3 seconds and 3 MB of main memory on a Pentium-M 1.7 GHz and can additionally be optimized for devices with slower CPUs. The same attack can be used ...
The physical phenomena on which the device relies (such as spinning platters in a hard drive) will also impose limits; for instance, no spinning platter shipping in 2009 saturates SATA revision 2.0 (3 Gbit/s), so moving from this 3 Gbit/s interface to USB 3.0 at 4.8 Gbit/s for one spinning drive will result in no increase in realized transfer rate.
Wireless security is another aspect of computer security. Organizations may be particularly vulnerable to security breaches [6] caused by rogue access points.. If an employee adds a wireless interface to an unsecured port of a system, they may create a breach in network security that would allow access to confidential materials.