Search results
Results from the WOW.Com Content Network
Derived from the scale of 1 inch equals 10 feet.TT model railroad scale. Used in AD&D Battlesystem Skirmishes rules. Works with 15 mm miniatures where a 6 foot man would equal 15.24 mm 1:110: 2.771 mm Used for some model ships, aircraft and diecast cars. 1:108: 2.822 mm
This is a list of firearm cartridges which have bullets of a caliber between 6 millimetres (0.236 in) and 6.99 millimetres (0.275 in). Length refers to the cartridge case length OAL refers to the overall length of the cartridge
The cartridge is a necked-up version of the .22 PPC which is in turn based on a .220 Russian (5.6×39mm). [5] The standard bullet diameter for 6 mm caliber cartridges is .243 inches (6.2 mm), the same diameter used in the .243 Winchester and 6mm Remington cartridges.
1 Comparison table. 2 See also. 3 Notes. 4 References. Toggle the table of contents. ... Inch: Double-trismégiste: Sabon Sechscicero [8] Kleine Sabon [22] 6 cicero ...
This specifies an exact scale of 1:60. That implies that a 28 mm tall figurine represents a 1.68 m (5 ft 6 in) person – which is a reasonable number for a modern 50th percentile male (See: Human height). Another popular scale is 1/72 or 1 inch equals 6 foot which uses 20 mm, to 25 mm miniatures.
The cartridge uses a 6.5 Grendel case that has been necked-down to accept a 6.2 mm (.243 in) bullet. [citation needed] The 6mm AR takes advantage of the wide variety of 6.2 mm (.243 in) caliber bullets. Slim, long bullets with high ballistic coefficient are ideal for energy retention at long ranges.
They then rounded to 2 significant figures in metric and then converting to inches and rounding to the thousandth of an inch. This anticipated worldwide metrication by about a century. The design was first proposed by the British Association in 1884 [ 1 ] [ 2 ] with a thread angle and depth based on the Swiss Thury thread , [ 3 ] it was adopted ...
A less precise definition is one pica equals 0.166 inches (4.2 mm), and one point 0.01383 inches (0.351 mm). [27] [33] It was also noticed that 83 picas is nearly equal to 35 cm, so the Type Founders Association also suggested using a 35 cm metal rod for measurements, but this was not accepted by every foundry. [27]