Search results
Results from the WOW.Com Content Network
A gate valve, also known as a sluice valve, is a valve that opens by lifting a barrier (gate) out of the path of the fluid. Gate valves require very little space along the pipe axis and hardly restrict the flow of fluid when the gate is fully opened. The gate faces can be parallel but are most commonly wedge-shaped (in order to be able to apply ...
A pneumatic gripper is a specific type of pneumatic actuator that typically involves either parallel or angular motion of surfaces, A.K.A. “tooling jaws or fingers” that will grip an object. The gripper makes use of compressed air which powers a piston rod inside the tool.Grippers exist both internal with and external bore grip with the ...
Within the gate valve, there is a gatelike disk that moves up and down perpendicular to the path of flow and seats against two seat faces to shut off flow. The velocity of the fluid against a partly opened disk may cause vibration and chattering which will ultimately lead to damage to the seating surfaces. This is a common way that gate valves ...
Cylinder, with slide valve removed to show ports A double-acting slide valve cylinder. Steam enters via the steam port SP, and is admitted by the slide valve SV through the upper passage S to push down the piston P. At the same time, exhaust steam from below the piston passes back up the lower passage S, via the valve cavity, to exhaust E. As ...
Valves are available in several types, based on design and purpose: Gate, plug, or ball valves – Isolation; Globe valve – Throttling; Needle valve – Throttling, usually with high precision but low flow; Butterfly or diaphragm valves – Isolation and throttling; Check valve – Preventing reverse flow (non-return)
The blue valve body is visible in-line with the pipe. The valve actuator opens or closes the butterfly disc of the valve based on electrical signals sent to the actuator. Another valve actuator is visible in the background, with windows to indicate the valve position. A valve actuator is the mechanism for opening and closing a valve. Manually ...
Constant lead barrel cam in an American Pacemaker lathe. This cam is used to provide a repeatable cross slide setting when threading with a single-point tool. A cylindrical cam, or barrel cam, is a cam in which the follower rides on the surface of a cylinder. In the most common type, the follower rides in a groove cut into the surface of a ...
The geometry of the way can vary depending on the situation. The most common types are flat, vee, and dovetail ways. Flat ways are used when there is little requirement for the slide to be constrained perpendicular to the axis of movement, or the constraint is being provided by another component or otherwise not needed, such as on the carriage of a lathe.