Search results
Results from the WOW.Com Content Network
The valve assembly is the appliance which will make the connection between the cylinder and the hose (which will send the air to a pressure reducer). It is constructed of forged aluminum alloy, and is angled to reduce stress of the connection made between the high-pressure female coupling of the high pressure hose.
Construction worker wearing an MSA Skullgard hard hat at Douglas Dam, Tennessee (), 1942. Mine Safety Appliances, or MSA Safety Incorporated, is an American manufacturer and supplier of safety equipment designed for use in a variety of hazardous conditions in industries such as construction, the military, fire service, and chemical, oil, and gas production.
To reduce pressure buildup from use, a pressure-relief valve with saliva trap is included. Closed-circuit SCBAs are also noticeably smaller than open-circuit ones. [9] Self-contained self-rescue devices are also closed-circuit SCBAs, working on the same principles, being designed for emergency use in mines, and lasting about one hour. [9]
Valves stop (or regulate) the flow of liquids or gases. They are categorized by application, such as isolation, throttling, and non-return. Isolation valves temporarily disconnect part of a piping system to allow maintenance or repair, for example. Isolation valves are typically left in either a fully open or closed position.
A control valve is a valve used to control fluid flow by varying the size of the flow passage as directed by a signal from a controller. [1] This enables the direct control of flow rate and the consequential control of process quantities such as pressure, temperature, and liquid level.
This inspection lamp is constructed so that it cannot set off an explosion when surrounded by specified flammable gases or dust. In electrical and safety engineering, hazardous locations (HazLoc, pronounced haz·lōk) are places where fire or explosion hazards may exist.
The 24-valve DOHC 1G-GTE added two CT-12 turbochargers to the versatile motor. There were 3 generations of this engine both air-to-air and air-to-water intercoolers were used, pushing output from 185 to 210 PS (136 to 154 kW; 182 to 207 hp) at 6200 rpm and 234 to 275 N⋅m (173 to 203 lb⋅ft) at 3800 rpm using the air-to-air over the air-to-water.
This engine was made with different valvetrain designs: 8 or 16 valve SOHC or 16 valve DOHC. All G13 engines have a bore and a stroke size of 74 mm × 75.5 mm (2.91 in × 2.97 in) except for the G13A engine which has a 77 mm (3.03 in) stroke.