Search results
Results from the WOW.Com Content Network
A selection of glue sticks manufactured by Pritt; "Pritt Stick (International version)", "Pritt Stick (UK version)" and Extra Strong "Power Pritt" Glue sticks are solid and hard adhesives in twist or push-up tubes. Users can apply glue by holding the open tube to keep their fingers clean and rubbing the exposed stick against a surface.
In this case, the plastic at the substrate surface is dissolved by the solvent contained in the adhesive. This leads to an increased mobility of the plastic's polymer chains, which in turn allows penetration by those of the adhesive. Ultimately, additional interactions occur between the polymer chains of the adhesive and the substrate.
Ethylene-vinyl acetate (EVA) copolymers, low-performance, the low-cost and most common material for the glue sticks (e.g., the light amber colored Thermogrip GS51, GS52, and GS53). [9] They provide sufficient strength between 30 °C (86 °F) and 50 °C (122 °F) but are limited to use below 60 °C (140 °F) to 80 °C (176 °F) and have low ...
Glue stick – Solid adhesive in a twist or push-up tube; Mucilage – Thick, gluey substance produced by nearly all plants and some microorganisms; Sealant – Substance used to block the passage of fluids through openings; Wood glue – Adhesive made of natural or synthetic raw materials for bonding wood and wood-based materials
An electrically conductive adhesive is a glue that is primarily used for electronics. The electric conductivity is caused by a component that makes ca. 80% of the total mass of an electrically conductive adhesive. This conductive component is suspended in a sticky component that holds the electrically conductive adhesive together.
The use of PVAc on the Archimedes Palimpsest during the 20th century greatly hindered the task of disbinding the book and preserving and imaging the pages in the early 21st century, in part because the glue was stronger than the parchment it held together. [7] In handicrafts. As envelope adhesive. As wallpaper adhesive.
Inflatable boats with transoms have an inflatable keel that creates a slight V-bottom along the line of the hull to improve the hull's seakeeping and directional stability. These vessels are very light, so if powered with an engine, it is best to put weight in the bow area to keep the bow from rising while the boat is going up on plane.
The one sheet boat (OSB, cf. oriented strand board) is an outgrowth of the stitch and glue technique. The OSB is a boat that can be built using a single sheet of 4 foot by 8 foot plywood (1.22 m × 2.44 m). Some additional wood is often used, for supports, chines, or as a transom, though some can be built entirely with the sheet of plywood ...