enow.com Web Search

Search results

1. Results from the WOW.Com Content Network

2. Screw terminal - Wikipedia

   en.wikipedia.org/wiki/Screw_terminal

   The wire may be wrapped directly under the head of a screw, may be held by a metal plate forced against the wire by a screw, or may be held by what is, in effect, a set screw in the side of a metal tube. The wire may be directly stripped of insulation and inserted under the head of a screw or into the terminal.

3. Electric wire ferrule - Wikipedia

   en.wikipedia.org/wiki/Electric_wire_ferrule

   Top: wire terminating in an insulated ferrule Center: Several ferrules with colored insulation, and two uninsulated ferrules Insulated, and uninsulated ferrules. An electric wire ferrule (sometimes electric end terminal) is a metal tube crimped over stranded wire to secure the strands within a screw terminal.

4. Electrical connector - Wikipedia

   en.wikipedia.org/wiki/Electrical_connector

   [6]: 56 (e.g. pin headers, screw terminals, board-to-board connectors) Splice or butt connectors (primarily insulation displacement connectors) that permanently join two lengths of wire or cable; In computing, electrical connectors are considered a physical interface and constitute part of the physical layer in the OSI model of networking.

5. FASTON terminal - Wikipedia

   en.wikipedia.org/wiki/FASTON_terminal

   FASTON terminals or faston terminals are connectors that are widely used in electronic and electrical equipment. These terminals are manufactured by many companies, commonly using the terms "quick disconnect", "quick connect", "tab" terminals, "spade" terminals [ 1 ] or blade connectors ; without qualifiers, the first two could be mistaken for ...

6. Lightbulb socket - Wikipedia

   en.wikipedia.org/wiki/Lightbulb_socket

   The two-pin socket is an update of the bi-post design with smaller pins designed to reduce the cost of manufacture. The 1000-watt FEL medium two-pin base halogen lamp allows designers to insert the lamp into the end of the ellipsoidal reflector through a smaller hole than previously possible with conventional incandescent lamps. This improves ...

7. 110 block - Wikipedia

   en.wikipedia.org/wiki/110_block

   A 110 punch block. A 110 block is a type of punch-down block used to terminate runs of on-premises wiring in a structured cabling system. The designation 110 is also used to describe a type of insulation displacement contact (IDC) connector used to terminate twisted pair cables, [1] which uses a punch-down tool similar to the type used for the older 66 block.