Search results
Results from the WOW.Com Content Network
Examples of sound pressure in air at standard atmospheric pressure; Source of sound Distance Sound pressure level [a] (dB SPL) Shock wave (distorted sound waves > 1 atm; waveform valleys are clipped at zero pressure) [11] [12] >1.01×10 5 >191 Simple open-ended thermoacoustic device [14] [clarification needed] 1.26×10 4: 176 1883 eruption of ...
The decibel originates from methods used to quantify signal loss in telegraph and telephone circuits. Until the mid-1920s, the unit for loss was miles of standard cable (MSC). 1 MSC corresponded to the loss of power over one mile (approximately 1.6 km) of standard telephone cable at a frequency of 5000 radians per second (795.8 Hz), and matched closely the smallest attenuation detectable to a ...
Sound intensity is not the same physical quantity as sound pressure. Human hearing is sensitive to sound pressure which is related to sound intensity. In consumer audio electronics, the level differences are called "intensity" differences, but sound intensity is a specifically defined quantity and cannot be sensed by a simple microphone.
A graph of the A-, B-, C- and D-weightings across the frequency range 10 Hz – 20 kHz Video illustrating A-weighting by analyzing a sine sweep (contains audio). A-weighting is a form of frequency weighting and the most commonly used of a family of curves defined in the International standard IEC 61672:2003 and various national standards relating to the measurement of sound pressure level. [1]
Dynamic range is a measure of how small you can measure a signal relative to the maximum input signal the device can measure. Expressed in decibels, the dynamic range is 20 log (Vmax/Vmin). For example, a device with an input range of ±10 V and a dynamic range of 110 dB will be able to measure a signal as small as 10 μV.
A noise dosimeter (American) or noise dosemeter (British) is a specialized sound level meter intended specifically to measure the noise exposure of a person integrated over a period of time; usually to comply with Health and Safety regulations such as the Occupational Safety and Health (OSHA) 29 CFR 1910.95 Occupational Noise Exposure Standard ...
Here is a table of some examples, from an on-line source. [5] For omnidirectional sources in free space, sound power in L wA is equal to sound pressure level in dB above 20 micropascals at a distance of 0.2821 m [6]
Whether using a sound level meter or a noise dosimeter, the processing is somewhat similar. With a calibrated sound level meter, the incoming sounds are going to be picked up by the microphone and then measured by the internal electronic circuits. [5] The sound measurement that the device outputs can be filtered through an A, B, or C weighting ...