enow.com Web Search

  1. Ads

    related to: 12 pioneer subwoofer 1000 watts 2 1/2 water float valve replacement

Search results

  1. Results from the WOW.Com Content Network
  2. Valve RF amplifier - Wikipedia

    en.wikipedia.org/wiki/Valve_RF_amplifier

    A valve RF amplifier (UK and Aus.) or tube amplifier is a device for electrically amplifying the power of an electrical radio frequency signal. Low to medium power valve amplifiers for frequencies below the microwaves were largely replaced by solid state amplifiers during the 1960s and 1970s, initially for receivers and low power stages of ...

  3. Valve audio amplifier technical specification - Wikipedia

    en.wikipedia.org/wiki/Valve_audio_amplifier...

    For higher impedances, such as 250 kΩ, the EF86's voltage noise is 1/10 1/2 lower than the sources's own noise, and the noise figure is ~1 dB. For a low-impedance source of 250 Ω, on the other hand, the noise contribution of the valve is 10 times larger than the signal source, and the noise figure is approximately ten, or 10 dB.

  4. Subwoofer - Wikipedia

    en.wikipedia.org/wiki/Subwoofer

    From about 1900 to the 1950s, the "lowest frequency in practical use" in recordings, broadcasting and music playback was 100 Hz. [9] When sound was developed for motion pictures, the basic RCA sound system was a single 8-inch (20 cm) speaker mounted in straight horn, an approach which was deemed unsatisfactory by Hollywood decisionmakers, who hired Western Electric engineers to develop a ...

  5. Valve amplifier - Wikipedia

    en.wikipedia.org/wiki/Valve_amplifier

    A valve amplifier or tube amplifier is a type of electronic amplifier that uses vacuum tubes to increase the amplitude or power of a signal. Low to medium power valve amplifiers for frequencies below the microwaves were largely replaced by solid state amplifiers in the 1960s and 1970s.

  6. Loudspeaker - Wikipedia

    en.wikipedia.org/wiki/Loudspeaker

    A horn-loaded speaker can have a sensitivity as high as 110 dB at 2.83 volts (1 watt at 8 ohms) at 1 meter. This is a hundredfold increase in output compared to a speaker rated at 90 dB sensitivity and is invaluable in applications where high sound levels are required or amplifier power is limited.

  7. 'Shocking and unconscionable': Joe Biden mourns victims of ...

    www.aol.com/news/shocking-unconscionable-joe...

    President Joe Biden urged Congress to pass 'commonsense' gun-safety laws following Wisconsin school shooting that killed two and wounded six others

  8. 10.2 surround sound - Wikipedia

    en.wikipedia.org/wiki/10.2_surround_sound

    The .2 of the 10.2 refers to the addition of a second subwoofer. The system is bass managed such that all the speakers on the left side use the left sub and all the speakers on the right use the right sub. The Center and Back Surround speakers are split among the two subs. The two subs also serve as two discrete LFE (Low Frequency Effects ...

  9. Vanderbilt beats Georgia Tech 35-27 in Birmingham Bowl for ...

    www.aol.com/vanderbilt-beats-georgia-tech-35...

    Georgia Tech's Haynes King tried to bring his team back from a 35-13 deficit with a 9-yard touchdown pass to Jamal Haynes with 5:03 left and a 2-yarder to Bailey Stockton at the 1:30 mark. Both ...

  1. Ads

    related to: 12 pioneer subwoofer 1000 watts 2 1/2 water float valve replacement