Search results
Results from the WOW.Com Content Network
Such passive adapters may be specific to the devices they came with; however, the most common configuration involves sharing the GND and Vcc (+5 V) pins of both protocols, connecting the USB D+ pin to the PS/2 +CLK pin, and connecting the USB D- pin to the PS/2 +DATA pin. Using such adapters requires a dual-mode controller on the keyboard or ...
The PS/2 peripherals were themselves replaced with USB-connected models. The HIL bus is a daisy-chain of up to 7 devices, running at a raw clock speed of 8 MHz. Each HIL device typically has an output connector, and an input connector to which the next device in the chain plugs; the exception is the mouse which has only the output connector.
Linux for PlayStation 2 (or PS2 Linux) is a kit released by Sony Computer Entertainment in 2002 that allows the PlayStation 2 console to be used as a personal computer.It included a Linux-based operating system, a USB keyboard and mouse, a VGA adapter, a PS2 network adapter (Ethernet only), and a 40 GB hard disk drive (HDD).
Paul, Matthias R. (2002-04-06). "Re: [fd-dev] ANNOUNCE: CuteMouse 2.0 alpha 1".freedos-dev.Archived from the original on 2020-02-07 […] The original Mouse Systems Bus Mouse is a normal serial 8250 compatible mouse using the normal Mouse Systems serial protocol, however the base address of this 8250 type chip is not one of the usual COM port addresses 3F8h, 2F8h, 3E8h, or 2E8h, but either ...
The official multitap for the PlayStation The official multitap for the PlayStation 2. The PlayStation Multitap is a peripheral for the PlayStation.It is an adapter that can be used to plug in up to four controllers and memory cards at the same time in a single controller port.
Simple adapters exist both for plugging PS/2-hardware into USB sockets, as well as for plugging USB-hardware into PS/2 sockets. -- Alexey Topol 16:31, 27 March 2010 (UTC) Yes, a section about adapters is appropriate. I bought an inexpensive adapter to connect a Logitech M-S48 PS/2 mouse and a Microsoft PS/2 Intellimouse to USB sockets.
The IBM PC game port first appeared during the initial launch of the original IBM PC in 1981, in the form of an optional US$55 expansion card known as the Game Control Adapter. [ 8 ] [ 9 ] The design allowed for four analog axes and four buttons on one port, allowing two joysticks or four paddles to be connected via a special "Y-splitter" cable.
The PC 97 standard requires that a computer's BIOS must detect and work with USB HID class keyboards that are designed to be used during the boot process. Some keyboards implement the USB Boot Keyboard profile specified in the USB Device Class Definition for Human Interface Devices (HID) v1.11 and are explicitly configured to use the boot protocol.