Search results
Results from the WOW.Com Content Network
Any meter will load the circuit under test to some extent. For example, a multimeter using a moving coil movement with full-scale deflection current of 50 microamps (μA), the highest sensitivity commonly available, must draw at least 50 μA from the circuit under test for the meter to reach the top end of its scale. This may load a high ...
IEC 62057-1 Electrical energy meters – Test equipment, techniques and procedures – Part 1: Stationary meter test units (MTUs) IEC 62057-3 Electrical energy meters – Test equipment, techniques and procedures – Part 3: Automatic meter testing system (AMTS) IEC 62058 Electricity metering equipment (AC) – Acceptance inspection
In electrical engineering, an electrical isolation test is a direct current (DC) or alternating current (AC) resistance test that is performed on sub-systems of an electronic system to verify that a specified level of isolation resistance is met. Isolation testing may also be conducted between one or more electrical circuits of the same ...
Thick-film heaters can largely be characterized under two subcategories – negative-temperature-coefficient (NTC) and positive-temperature-coefficient (PTC) materials – based on the effect of temperature changes on the element's resistance. NTC-type heaters are characterized by a decrease in resistance as the heater temperature increases and ...
Stiff diagrams can be used: 1) to help visualize ionically related waters from which a flow path can be determined, or; 2) if the flow path is known, to show how the ionic composition of a water body changes over space and/or time. Example of a Stiff diagram. A typical Stiff diagram is shown in the figure (right).
Piper diagram of water samples from the Mtshabezi River, Zimbabwe. Data source: [2] A Piper diagram is a graphical representation of the chemistry of a water sample or samples. The cations and anions are shown by separate ternary plots. The apexes of the cation plot are calcium, magnesium and sodium plus potassium cations.
An immersion heater has an electrical resistance heating element encased in a tube, placed in the water (or other fluid) to be heated. The heating element might be inserted directly into the liquid, or installed inside a metal pipe to protect against corrosion and facilitate maintenance.
In electrical engineering, characteristics like current or voltage can be measured by an ammeter, a voltmeter, a multimeter, etc. The ammeter is used in series with the load, so the same current flows through the load and the ammeter.