Search results
Results from the WOW.Com Content Network
The 8052 was an enhanced version of the original 8051 that featured 256 bytes of internal RAM instead of 128 bytes, 8 KB of ROM instead of 4 KB, and a third 16-bit timer. Most modern 8051-compatible microcontrollers include these features. The 8032 had these same features as the 8052 except it lacked internal ROM program memory.
MCU 8051 IDE is a free software integrated development environment for microcontrollers based on the 8051. MCU 8051 IDE has a built-in simulator not only for the MCU itself, but also LCD displays and simple LED outputs as well as button inputs.
Delay calculation is the term used in integrated circuit design for the calculation of the gate delay of a single logic gate and the wires attached to it. By contrast, static timing analysis computes the delays of entire paths, using delay calculation to determine the delay of each gate and wire.
The Small Device C Compiler (SDCC) is a free-software, partially retargetable [1] C compiler for 8-bit microcontrollers. It is distributed under the GNU General Public License. The package also contains an assembler, linker, simulator and debugger. SDCC is a popular open-source C compiler for microcontrollers compatible with Intel 8051/MCS-51 ...
The form comes with two worksheets, one to calculate exemptions, and another to calculate the effects of other income (second job, spouse's job). The bottom number in each worksheet is used to fill out two if the lines in the main W4 form. The main form is filed with the employer, and the worksheets are discarded or held by the employee.
In static timing analysis, the word static alludes to the fact that this timing analysis is carried out in an input-independent manner, and purports to find the worst-case delay of the circuit over all possible input combinations. The computational efficiency (linear in the number of edges in the graph) of such an approach has resulted in its ...
A watchdog timer (WDT, or simply a watchdog), sometimes called a computer operating properly timer (COP timer), [1] is an electronic or software timer that is used to detect and recover from computer malfunctions. Watchdog timers are widely used in computers to facilitate automatic correction of temporary hardware faults, and to prevent errant ...
To initialize the counters, the microprocessor must write a control word (CW) in this register. This can be done by setting proper values for the pins of the Read/Write Logic block and then by sending the control word to the Data/Bus Buffer block. The control word register contains 8 bits, labeled D7..D0 (D7 is the MSB). The decoding is ...