enow.com Web Search

Search results

1. Results from the WOW.Com Content Network

2. Self-tapping screw - Wikipedia

   en.wikipedia.org/wiki/Self-tapping_screw

   A self-tapping screw is a screw that can tap its own hole as it is driven into the material. More narrowly, self-tapping is used only to describe a specific type of thread-cutting screw intended to produce a thread in relatively soft material or sheet materials, excluding wood screws .

3. List of drill and tap sizes - Wikipedia

   en.wikipedia.org/wiki/List_of_drill_and_tap_sizes

   Example (inch, coarse): For size 7 ⁄ 16 (this is the diameter of the intended screw in fraction form)-14 (this is the number of threads per inch; 14 is considered coarse), 0.437 in × 0.85 = 0.371 in. Therefore, a size 7 ⁄ 16 screw (7 ⁄ 16 ≈ 0.437) with 14 threads per inch (coarse) needs a tap drill with a diameter of about 0.371 inches.

4. Tap and die - Wikipedia

   en.wikipedia.org/wiki/Tap_and_die

   Integrated screws appear to be common in the US but are almost unknown in the UK and Europe. The dies shown in the image to the right are adjustable: top left: an older split die, with top adjusting screw; bottom left: a one piece die with top adjusting screw; center: a one piece die with side adjusting screw (barely visible on the full image)

5. Computer case screws - Wikipedia

   en.wikipedia.org/wiki/Computer_case_screws

   The #6-32 UNC screw has a thread pitch of 1/32 in (0.031250 inches (0.7938 mm)). The #6-32 UNC is a UTS screw specifying a major thread diameter of #6 which is defined as 0.1380 inches (3.51 mm); and 32 tpi (threads per inch) which equates to a thread pitch of 0.031250 inches (0.7938 mm). The optional UNC specification indicates the standard ...

6. Screw - Wikipedia

   en.wikipedia.org/wiki/Screw

   A machine screw or bolt is usually a smaller fastener (less than 1 ⁄ 4 inch (6.35 mm) in diameter) threaded the entire length of its shank that usually has a recessed drive type (slotted, Phillips, etc.), usually intended to screw into a pre-formed thread, either a nut or a threaded (tapped) hole, unlike a wood or self-tapping screw. Machine ...

7. Drill bit - Wikipedia

   en.wikipedia.org/wiki/Drill_bit

   From top: Spade, brad point, masonry, and twist drills bits Drill bit (upper left), mounted on a pistol-grip electric drill A set of masonry drills A drill bit is a cutting tool used in a drill to remove material to create holes, almost always of circular cross-section.