Search results
Results from the WOW.Com Content Network
A speaker system has to be wired to accommodate either configuration, typically with two sets of binding posts, one set for the bass and one set for the mid-highs. A single amplifier can usually power a woofer and a tweeter only through a post-amplifier crossover filter, which protects each driver from signals outside its frequency range.
Acoustic suspension or air suspension is a variation of the closed-box enclosure, using a box size that exploits the almost linear air spring resulting in a −3 dB low-frequency cut-off point of 30–40 Hz from a box of only one to two cubic feet or so. [16]
Three audio power amplifiers Rear panel of a power amplifier with 2 × 700 Watt (4 Ohm) - very similar to the topmost device in the image above - showing typical connectors for professional use: From left, symmetrical XLR-sockets for signal input, alternatively audio jack sockets, loudspeaker terminals of type Speakon (center), alternatively ...
The issue of linearity in a power amplifier can theoretically be mitigated by requiring that the input signal of the power amplifier be "constant envelope", i.e. contain no amplitude variations. In a polar modulation system, the power amplifier input signal may vary only in phase.
The system is arranged in such a way that the outputs from the amplifiers are inverted with respect to each other. In other words, as the signal in one amplifier is swinging positively, the signal in the other is swinging negatively. When the output of one amplifier is at +10 volts the output of the other will be at −10 volts, and vice versa.
In electronics, a common-gate amplifier is one of three basic single-stage field-effect transistor (FET) amplifier topologies, typically used as a current buffer or voltage amplifier. In this circuit, the source terminal of the transistor serves as the input, the drain is the output, and the gate is connected to some DC biasing voltage (i.e. an ...
Demodulation is the process of extracting the original information-bearing signal from a carrier wave.A demodulator is an electronic circuit (or computer program in a software-defined radio) that is used to recover the information content from the modulated carrier wave. [1]
A double-tuned transformer from a radio receiver intermediate-frequency amplifier with its screening can removed. A double-tuned amplifier is a tuned amplifier with transformer coupling between the amplifier stages in which the inductances of both the primary and secondary windings are tuned separately with a capacitor across each.