enow.com Web Search

Search results

1. Results from the WOW.Com Content Network

2. IEEE 802.3 - Wikipedia

   en.wikipedia.org/wiki/IEEE_802.3

   IEEE 802.3 is a working group and a collection of standards defining the physical layer and data link layer's media access control (MAC) of wired Ethernet.The standards are produced by the working group of Institute of Electrical and Electronics Engineers (IEEE).

3. Fast Ethernet - Wikipedia

   en.wikipedia.org/wiki/Fast_Ethernet

   Fast Ethernet is an extension of the 10-megabit Ethernet standard. It runs on twisted pair or optical fiber cable in a star wired bus topology , similar to the IEEE standard 802.3i called 10BASE-T , itself an evolution of 10BASE5 (802.3) and 10BASE2 (802.3a).

4. List of interface bit rates - Wikipedia

   en.wikipedia.org/wiki/List_of_interface_bit_rates

   This is a list of interface bit rates, is a measure of information transfer rates, or digital bandwidth capacity, at which digital interfaces in a computer or network can communicate over various kinds of buses and channels.

5. Category 5 cable - Wikipedia

   en.wikipedia.org/wiki/Category_5_cable

   The cable standard prescribes performance parameters for frequencies up to 100 MHz and is suitable for 10BASE-T, 100BASE-TX (Fast Ethernet), 1000BASE-T (Gigabit Ethernet), and 2.5GBASE-T. 10BASE-T and 100BASE-TX Ethernet connections require two wire pairs. 1000BASE-T and faster Ethernet connections require four wire pairs.

6. Ethernet physical layer - Wikipedia

   en.wikipedia.org/wiki/Ethernet_physical_layer

   Common connectors Description Twisted-pair cable 100BASE‑T: 802.3u-1995 (21) A term for any of the three standards for 100 Mbit/s Ethernet over twisted pair cable. Includes 100BASE-TX, 100BASE-T4 and 100BASE-T2. As of 2009, 100BASE-TX has totally dominated the market, and may be considered synonymous with 100BASE-T in informal usage. 100BASE-TX

7. Ethernet over twisted pair - Wikipedia

   en.wikipedia.org/wiki/Ethernet_over_twisted_pair

   Most Ethernet cables are wired straight-through (pin 1 to pin 1, pin 2 to pin 2, and so on). In some instances, the crossover form (receive to transmit and transmit to receive) may still be required. Cables for Ethernet may be wired to either the T568A or T568B termination standards at both ends of the cable. Since these standards differ only ...