Search results
Results from the WOW.Com Content Network
Coolant delivery 3 phase thermostat, timing chain driven water pump rated 420 litres (110 US gal; 92 imp gal) /min flow Oil delivery 9 litres (2.4 US gal; 2.0 imp gal) oil, dry-sump, via two-stage controlled suction pump (250 litres (66 US gal; 55 imp gal) /min), a pressure pump and a 12 litres (3.2 US gal; 2.6 imp gal) external oil tank
1.0 imp bsh (36 L; 8.0 imp gal; 8.3 US dry gal) impbu imp bu imperial kenning: impkenning kenning 1.0 ...
A Fixture Unit is not a flow rate unit but a design factor. A fixture unit is equal to 1 cubic foot (0.028 m 3) of water drained in a 1 + 1 ⁄ 4 inches (32 mm) diameter pipe over one minute. [2] One cubic foot of water is roughly 7.48 US gallons (28.3 L; 6.23 imp gal). A Fixture Unit is used in plumbing design for both water supply and waste ...
The dry-sump system uses two or more oil pumps and a separate oil reservoir, as opposed to a conventional wet-sump system, which uses only the main sump (U.S.: oil pan) below the engine and a single pump. A dry-sump engine requires a pressure relief valve to regulate negative pressure inside the engine, so internal seals are not inverted.
Waterbed mattresses, depending on the size, hold about 80–235 US gal (300–890 L) of water, which could bring the weight of the entire bed to over 2,000 lb (910 kg). This weight could pose a risk to the floor the bed is on.
In most production automobiles and motorcycles, which use a wet sump system, the oil is collected in a 3 to 10 litres (0.66 to 2.20 imp gal; 0.79 to 2.64 US gal) capacity pan at the base of the engine, known as the sump or oil pan, where it is pumped back up to the bearings by the internal oil pump.
Two common strategies are “greenwashing” and the “water bed effect” – both of which can lead to higher store prices. See: 8 Items To Stop Buying at Grocery Stores If You Want To Save Money
The Unit Pump system [1] is a modular high-pressure diesel injection system, which is closely related to the unit Injector system, and is designed for use in commercial vehicle diesel engines. [ 2 ] The systems use an individual injection pump mounted on the engine block for each cylinder so it is primarily designed for OHV or "cam in the block ...