Search results
Results from the WOW.Com Content Network
Exhaust gas or flue gas is emitted as a result of the combustion of fuels such as natural gas, gasoline (petrol), diesel fuel, fuel oil, biodiesel blends, [1] or coal. According to the type of engine, it is discharged into the atmosphere through an exhaust pipe , flue gas stack , or propelling nozzle .
In an internal combustion engine, the expansion of the high-temperature and high-pressure gases produced by combustion applies direct force to some component of the engine. The force is typically applied to pistons (piston engine), turbine blades (gas turbine), a rotor (Wankel engine), or a nozzle . This force moves the component over a distance.
The combustion of hydrogen with oxygen produces water vapor as its only product: 2H 2 + O 2 → 2H 2 O. However, air is a mixture of gases, and the most abundant gas in air is nitrogen. Therefore, the combustion of hydrogen in air produces oxides of nitrogen, known as NO x. In this respect, the combustion process is much like other high ...
A gas engine differs from a petrol engine in the way the fuel and air are mixed. A petrol engine uses a carburetor or fuel injection. but a gas engine often uses a simple venturi system to introduce gas into the air flow. Early gas engines used a three-valve system, with separate inlet valves for air and gas.
= the mass rate of total air flow entering the turbofan = ṁ c + ṁ f: ṁ c = the mass rate of intake air that flows to the core engine ṁ f = the mass rate of intake air that bypasses the core engine v f = the velocity of the air flow bypassed around the core engine v he = the velocity of the hot exhaust gas from the core engine v o
Exhaust gas—which consists largely of nitrogen, carbon dioxide, and water vapor—has a higher specific heat than air, so it still serves to lower peak combustion temperatures. However, adding EGR to a diesel reduces the specific heat ratio of the combustion gases in the power stroke .
Comparing air and water, air has vastly lower heat capacity per gram and per volume (4000) and less than a tenth the conductivity, but also much lower viscosity (about 200 times lower: 17.4 × 10 −6 Pa·s for air vs 8.94 × 10 −4 Pa·s for water). Continuing the calculation from two paragraphs above, air cooling needs ten times of the ...
It was first produced in 1910 by Walter O. Snelling, and the first commercial products appeared in 1912. It currently provides about 3% of all energy consumed, and burns relatively cleanly with no soot and very little sulfur emission. As it is a gas, it does not pose ground or water pollution hazards, but it can cause air pollution.