enow.com Web Search

Search results

1. Results from the WOW.Com Content Network

2. Surge protector - Wikipedia

   en.wikipedia.org/wiki/Surge_protector

   Surge protection device (SPD) for installation in a low-voltage distribution system. A surge protector, spike suppressor, surge suppressor, surge diverter, [1] surge protection device (SPD), transient voltage suppressor (TVS) or transient voltage surge suppressor (TVSS) is an appliance or device intended to protect electrical devices in alternating current (AC) circuits from voltage spikes ...

3. Power conditioner - Wikipedia

   en.wikipedia.org/wiki/Power_conditioner

   A power conditioner (also known as a line conditioner or power line conditioner) is a device intended to improve the quality of the power that is delivered to electrical load equipment. The term most often refers to a device that acts in one or more ways to deliver a voltage of the proper level and characteristics to enable load equipment to ...

4. Power strip - Wikipedia

   en.wikipedia.org/wiki/Power_strip

   A North American power strip with two USB power ports that includes a built in surge protector. A power strip (also known as a multi-socket, power board and many other variations [a]) is a block of electrical sockets that attaches to the end of a flexible cable (typically with a mains plug on the other end), allowing multiple electrical devices to be powered from a single electrical socket.

5. Uninterruptible power supply - Wikipedia

   en.wikipedia.org/wiki/Uninterruptible_power_supply

   Outdoor UPS systems can either be pole, ground (pedestal), or host mounted. Outdoor environment could mean extreme cold, in which case the outdoor UPS system should include a battery heater mat, or extreme heat, in which case the outdoor UPS system should include a fan system or an air conditioning system. Internal view of a solar inverter.

6. Transient-voltage-suppression diode - Wikipedia

   en.wikipedia.org/wiki/Transient-voltage...

   A transient-voltage-suppression diode can respond to over-voltages faster than other common over-voltage protection components such as varistors or gas discharge tubes. The actual clamping occurs in roughly one picosecond, but in a practical circuit the inductance of the wires leading to the device imposes a higher limit. This makes transient ...

7. Network protector - Wikipedia

   en.wikipedia.org/wiki/Network_protector

   The network protector is installed to protect the stability and reliability of the secondary grid by preventing power flow away from the customers and into the primary feeders. If there is a fault on the primary feeder, the substation circuit-breaker is meant to open, disconnecting the primary feeder from one side.