Search results
Results from the WOW.Com Content Network
In recording and post production, configuring a send to be pre-fader allows the amount of audio sent to the aux bus to remain unaffected by the individual track fader, thus not disturbing the stability of the feed that is being sent to the musicians. [22]
A post-fader output is used in order to prevent channels whose faders are at zero gain from "contaminating" the effects-return loop with hiss and hum. Mixing consoles most commonly have a group of aux-send knobs in each channel strip, or, on small mixers, a single aux-send knob per channel, where one knob corresponds to each aux-send on the board.
The signal from the cue system is fed to the console's headphone amp and may also be available as a line-level output that is intended to drive a monitor speaker system. The terms AFL (after-fader listen) and PFL (pre-fader listen) are used to describe respectively whether or not the level of the cue signal for an input is controlled by the ...
TOS/360 (IBM's Tape Operating System) Livermore Time Sharing System (LTSS) Multics (MIT, GE, Bell Labs for the GE-645) (announced) Pick operating system; SIPROS 66 (Simultaneous Processing Operating System) [6] THE multiprogramming system (Technische Hogeschool Eindhoven) development; TSOS (later VMOS) 1966 DOS/360 (IBM's Disk Operating System)
In audio engineering, a gain stage is a point during an audio signal flow that the engineer can make adjustments to the level, [1] such as a fader on a mixing console or in a DAW.
The operating system keeps its processes separate and allocates the resources they need, so that they are less likely to interfere with each other and cause system failures (e.g., deadlock or thrashing). The operating system may also provide mechanisms for inter-process communication to enable processes to interact in safe and predictable ways.
Typical POST screen (AMI BIOS) Typical UEFI-compliant BIOS POST screen (Phoenix Technologies BIOS) Summary screen after POST and before booting an operating system (AMI BIOS) A power-on self-test ( POST ) is a process performed by firmware or software routines immediately after a computer or other digital electronic device is powered on.
A process is a program in execution, and an integral part of any modern-day operating system (OS). The OS must allocate resources to processes, enable processes to share and exchange information, protect the resources of each process from other processes and enable synchronization among processes.